10254070 Mercury OWNERS MANUAL, EFI L4NA, English

Table 1
System Configuration Parameters    
Parameter    Available Range or Options    Default    Required Password    
Rating Number     1 or 2     1     None    
Rated Power (1)     Read Only    
Rated Peak Torque (1)     Read Only    
Top Engine Speed Range (1)     Read Only    
Test Spec (1)     Read Only    
Equipment ID (2)     17 alphanumeric characters     NOT PROGRAMMED     None    
Engine Serial Number (2)     0XX00000 or XXX00000     0XX00000     None    
ECM Serial Number (1)     Read Only    
ECM Part Number (1)     Read Only    
Software Group Part Number (1)     Software Dependent     Read Only    
Software Group Release Date (1)     Software Dependent     Read Only    
Software Group Description (1)     Software Dependent     Read Only    
FLS (Full Load Setting) (2)     -128 to 127     0     Factory    
FTS (Full Torque Setting) (2)     -128 to 127     0     Factory    
Ether Solenoid Configuration (2)     No Ether
Continuous Flow     Continuous Flow     None    
System Battery Voltage Low Elevated Idle (2)     Disabled
Enabled     Enabled     None    
Total Tattletale     Read Only    
( 1 ) The parameter can only be viewed. No changes are allowed.
( 2 ) The parameter must be reprogrammed if the ECM is replaced.Parameter Descriptions
Rating Number
The scraper engine has two power ratings. The engine power rating automatically changes according to the actual gear status of the scraper transmission.The "Rating Number" parameter provides a way for you to view the information for both ratings. When you change this parameter, the values for the following parameters will be displayed for viewing:
Rated Power
Rated Peak Torque
Top Engine Speed Range
Test SpecEquipment ID
"Equipment ID" allows the customer to enter a description into the Electronic Control Module (ECM) in order to identify the machine. A maximum of 17 characters may be entered in the field. This parameter is only for reference by the customer. This parameter is not required.Engine Serial Number
Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. If the ECM is replaced, the engine serial number from the engine information plate must be programmed into the new ECM.Note: When you are requesting factory passwords, always use the engine serial number that is programmed in the ECM.FLS (Full Load Setting)
"FLS" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Factory passwords are required in order to change this parameter.FTS (Full Torque Setting)
"FTS" is similar to "FLS". Factory passwords are required in order to change this parameter.Ether Solenoid Configuration
Program the "Ether Solenoid Configuration" to "Continuous Flow" if an ether injection system is installed on the engine.System Battery Voltage Low Elevated Idle
Set the "System Battery Voltage Low Elevated Idle" parameter to "Enabled" in order to help maintain a proper charge on the batteries when electrical accessories have been added by the customer. When this parameter is set to "Enabled", the engine rpm will increase to 1000 when the following conditions are met:
The parking brake is engaged.
The transmission is in neutral.
The throttle has been below 25 percent for at least five minutes.
The battery voltage has been less than 24.5 VDC for at least five minutes.The engine rpm will return to low idle when any of the following conditions occur:
The parking brake is released.
The transmission is not in neutral.
The throttle is above 25 percent.Parameters Worksheet
Table 2
Engine Parameters    
Rating Number    
   
Rated Power    
   
Rated Peak Torque    
   
Top Engine Speed Range    
   
Test Spec    
   
Equipment ID    
   
Engine Serial Number    
   
ECM Serial Number    
   
ECM Part Number    
   
Software Group Part Number    
   
Software Group Release Date