895156 Mercury PLATE, Water Seal

Cut gaskets even with the bottom of front housing and front plate after the housing is installed on the engine.(1) Tighten the two studs to a torque of ... 55 7 N m (40 5 lb ft)(2) Bolts. Put 5P3413 Pipe Sealant on the threads of the two bolts at assembly.(3) Studs. Put 5P3413 Pipe Sealant on the thread of the two studs at assembly.(4) Put 9S3263 Thread Lock on the stud serrations and each side of the gasket before installation in the timing gear plate and cylinder block. Head of three studs must not be more the 4.6 mm (.18 in) beyond the timing gear plate after it is installed. Put 5P3413 Pipe Sealant on the stud threads.(5) Studs. Put 5P3413 Pipe Sealant on the threads of the eight studs at assembly. Studs (3) and (5) must be installed to extend above the housing surface to a dimension of 26.0 1.5 mm (1.02 .06 in).(245B)
Cut gaskets even with the bottom of front housing and front plate after the housing is installed on the engine.(1) Tighten the two studs to a torque of ... 65 10 N m (48 7 lb ft)(2) Tighten the two nuts to a torque of ... 65 10 N m (48 7 lb ft)(All Others)
Typical Illustration Cut gaskets even with the bottom of front housing and front plate after the housing is installed on the engine.(1) Tighten the two studs to a torque of ... 55 5 N m (40 4 lb ft)(2) Put 5P3413 Pipe Sealant on the threads of the two bolts at assembly. Tighten the bolts to a torque of ... 45 7 N m (33 5 lb ft) On model 245B, tighten three bolts to a torque of ... 55 7 N m (40 5 lb ft)(3) Tighten three bolts marked "X" to a torque of ... 45 7 N m (33 5 lb ft)(4) Put 9S3263 Thread Lock on the threads of the two studs at assembly. Tighten the two nuts that hold cover on the studs to a torque of ... 45 7 N m (33 5 lb ft) Studs (4) must be installed to extend above the housing surface to a dimension of ... 28.5 1.5 mm (1.12 .06 in)(5) Put 9S3263 Thread Lock on the threads of the eight studs at assembly and tighten to a torque of ... 35 5 N m (26 4 lb ft) On models 245 and 16G, eight studs (5) must be installed to extend above the housing surface to a dimension of 28.5 1.5 mm (1.12 .06 in) On models 824C, 825C, 826C and 980C, eight studs (5) must be installed to extend above the housing surface to a dimension of 41.0 1.5 mm (1.61 .06 in)(6) On each of the three studs, put 9S3263 Thread Lock on the stud serrations and each side of the gasket before installation in the timing gear plate and cylinder block. Heads of studs (6) must not be more than 4.5 mm (.18 in) above the surface of the timing gear plate after installation.