802809A 1 Mercury SENSOR ASSEMBLY, Overheat


802809A 1 SENSOR ASSEMBLY, Overheat Mercury 1040203FL, 1040203YL, 1040213YL SENSOR

Buy SENSOR ASSEMBLY, Overheat 802809A 1 Mercury genuine, new aftermarket parts with delivery
Number on catalog scheme: 21
 

Compatible models:

Mercury entire parts catalog list:

1040203FL 2006
1040203YL 2001,2002,2003,2004
1040213YL 2001,2004

Information:


Table 1
Service Error Identifiers Description Troubleshooting
$0003 Another Service Test is Active Only one service test may be active on a machine or engine at a time.
$0004 Service Test Active by Another ECM Another Service test from a different ECM is active. Either wait until completed or abort the test to proceed.
$0005 Loss of Service Test Interlock There is a communication issue between the ECM and ET. There is too much data communicating across the data link. Disconnect any other data collecting tools like CANape, CANcases, and Supercom2.
$0006 Service Test Aborted by Tool/Monitor Abort by user, Restart the test if desired
$101A Incorrect Throttle Position The throttle is depressed or faulty. If the application contains a rabbit/turtle, it maybe faulty.
Fuel System Functional Test
$111D Fuel Rail High Pressure Decay Too High Refer to Troubleshooting, "Fuel Rail Pressure is Low". Refer to Test Step "Perform Fuel System Functional Test".
$111E Fuel Rail Low Pressure Decay Too High
$111F Fuel Pump Flow Too Low
$1120 Fuel Pump Timing Incorrect
$1108 Excessive Engine RPM Change Do not allow engine RPM to fluctuate more than 100 RPM during test.
$108C Coolant Temp Low Coolant temperature must be greater than 40° C (104° F)
$0002 Active Diagnostic Present Resolve any active diagnostic codes. Refer to the appropriate troubleshooting procedure.
$10CB Engine Load Too High Fuel rate is too high for the test. Reduce load applied to the engine during the test.
Fuel System Verification Test
$10CB Engine Load Too High Fuel rate is too high for the test. Reduce load applied to the engine during the test.
$10D0 Engine Has Not Been Running Long Enough Engine must be running during the test, start the engine before starting the test.
$0002 Active Diagnostic Present Resolve any active diagnostic codes. Refer to the appropriate troubleshooting procedure.
Injector Fuel Delivery Test
$10CB Engine Load Too High Fuel rate is too high for the test. Reduce load applied to the engine during the test.
$10D0 Engine Has Not Been Running Long Enough Engine must be running during the test, start the engine before starting the test.
$108C Coolant Temp Low Coolant temperature must be greater than 65° C (149° F)
$0002 Active Diagnostic Present Resolve any active diagnostic codes. Refer to the appropriate troubleshooting procedure.
$0009 Service Test Aborted by ECM Check the service tool connection, do not abort the test before the test is complete. Repeat the test, if necessary.
NOx Sensor Functional Test
$0002 Active Diagnostic Present Resolve any active diagnostic codes. Refer to the appropriate troubleshooting procedure.
$10FC Engine Speed Too High Lower the engine speed to idle.
$10F5 Excessive Change in Engine Load There was a change in the engine load while the test was running. Make sure that the engine load is constant while performing the test.
$1164 Engine Speed/Load Incorrect The engine speed or load is above a threshold, remove the load from the engine or reduce the engine speed to idle.
Coolant Diverter Valve Test
$0002 Active Diagnostic Present Resolve any active diagnostic codes. Refer to the appropriate troubleshooting procedure.
$0006 Aborted by User The user has aborted the test.
$0009 Test Aborted by ECM The ECM lost communication with the service tool.
$10A7 Coolant Temperature Too Low The engine coolant temperature is too low to start the test. Allow the engine to reach operating temperature prior to performing the test.


Parts sensor Mercury:

851846
SENSOR
851846 SENSOR
1040203FL, 1040203YL, 1040213YL
Back to top