90824 Mercury TEE

Parameter Descriptions
Equipment ID
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the engine's application. A maximum of 17 characters can be entered in the field.Engine Serial Number
Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM.ECM Part Number
This parameter identifies the part number for the ECM.ECM Serial Number
This parameter identifies the serial number for the ECM.Software Group Part Number
This parameter identifies the part number of the flash file that is currently installed in the ECM.Software Group Release Date
This parameter identifies the release date of the flash file that is currently installed in the ECM.Software Group Description
This parameter identifies the description of the application for the flash file that is currently installed in the ECM.Full Load Setting (FLS)
FLS is a parameter that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.Full Torque Setting (FTS)
FTS is similar to FLS. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter."Maintenance Indicator Mode"
The ECM records data that is related to equipment maintenance. The ECM will activate the maintenance indicator lamp when scheduled maintenance is due. The maintenance indicator lamp can be reset by actuating the maintenance clear switch. The maintenance interval may be based on operating hours. The ECM provides information that pertains to maintenance intervals and the last maintenance that was performed."PM1 Interval"
"PM1 Interval" allows the customer to define the maintenance interval if "Maintenance Indicator Mode" is programmed to one of the manual options. Refer to the engine's Operation and Maintenance Manual for more information.Parameter Table
Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
Equipment ID 17 characters Not Programmed
Engine Serial Number 8 characters Not Programmed
ECM Part Number Read Only
ECM Serial Number Read Only
Software Group Part Number Read Only
Software Group Release Date Read Only
Software Group Description Read Only
FLS -127 to +127 Not Programmed Factory
FTS -127 to +127 Not Programmed Factory
Maintenance Indicator Mode Off/Manual hours Off
PM1 Interval 5 - 1000 hours 250 hours Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters
Equipment ID
Engine Serial Number
ECM Part Number
ECM Serial Number
Software Group Part Number
Software Group Release Date
Software Group Description
FLS
FTS
Maintenance Indicator Mode
PM1 Interval
Total Tattletale
Table 3
Information From Engine Information Plate
Engine Serial Number
Full Load Setting
(for new ECM)
Full Torque Setting
(for new ECM)
Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Only change the FLS and the FTS because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine. The use of the wrong parameters may also void the Caterpillar warranty.