346-83732-0 Nissan GROMMET, THROTTE CABLE

G3600 ESS Programming Examples
Message 1
This example will obtain the following information from a G3600 ESS system.
Engine Speed
Engine Timing
Fuel Position
Data will be sent in 0.5 second intervals from the CCM to the host equipment.
Data will be separated by commas.
Program the following message: <-50001315011301000000400041F111 00000000000000000000cs ->506115021300cs
Activate the message: <-5000110101cs ->506115021100cs Message 2
This example will obtain the following information from a G3600 ESS system.
Fuel Flow
Air Flow
BTU reading
Air Temperature
Data will be sent in one second intervals from the CCM to the host device.
Data will not have any separators.
Program the following message: <-500013150213020020F518F51EF51AF511 0000000000000000cs ->506115021300cs
Activate the message: <-5000110102cs ->506115021100cs Message 3
This example will obtain the diagnostic codes from the G3600 ESS system in 5 second intervals.
Send the following message: <-50008203130100cs ->506115028200cs
The messages will come from the CCM in the following format. ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100A0213ddd1ddd2ddd3ddd4cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100A0213ddd1ddd2ddd3ddd4cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100A0213ddd1ddd2ddd3ddd4cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100A0213ddd1ddd2ddd3ddd4cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100A0213ddd1ddd2ddd3ddd4cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100C0113,ddd1,ddd2,ddd3,cs ->5061100A0213ddd1ddd2ddd3ddd4cs ->5061820301F40Ccs This pattern will then repeat. Shutting Off The Messages
To turn off the messages, the following messages must be sent. The messages can be sent at any time.Turn OFF Message 1 <-5000120101cs ->506115021200csTurn OFF Message 2 <-5000120102cs ->506115021200csTurn OFF Message 3 (diagnostic codes) <-50008203130180cs ->506115028200csDiagnostic Codes - Retrieve
The CCM allows the diagnostic codes to be read from the CCM and the Gas Engine Controller. This is accomplished by using IID 82 or IID 24. Requesting Diagnostic Codes for the CCM
Use IID 24 with PID 0082 to retrieve the codes for the CCM. The format for the message is given below.5000240400610082csThe CCM responds with two data bytes. Each E code on the display represents a bit in the two bytes of data. Refer to Operation and Maintenance Manual, SEBU7014, "Diagnostic Code - Troubleshoot" in this manual.Requesting Diagnostic Codes for the G3600
The diagnostic codes for