11413-06208 Gasket, Upper Oil Seal Suzuki
20ELB, 20ELC, 20ELN, 25ELB, 25ELC, 25ELN, DT20ESB, DT20ESC, DT20ESN, DT20MLB, DT20MLC, DT20MLN, DT20MSB, DT20MSC, DT20MSN, DT25ESB, DT25ESC, DT25ESN, DT25MLB, DT25MLC, DT25MLN, DT25MSB, DT25MSC, DT25MSN, DT28F
Gasket
Price: query
Rating:
Compatible models:
Suzuki entire parts catalog list:
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
- Exhaust Cover » 11413-06208
Information:
Illustration 1 g01785156
Typical Range of Throttle
(1) Lower Diagnostic Limit (Default=5)
(2) Lower Position Limit (Default=10)
(3) Initial Lower Position (Default=20)
(4) Idle Validation Minimum Off Threshold (Default=21)
(5) Idle Validation Maximum On Threshold (Default=25)
(6) Lower Dead Zone % (Default=8)
(7) Upper Dead Zone % (Default=5)
(8) Initial Upper Position (Default=70)
(9) Upper Position Limit (Default=85)
(10) Upper Diagnostic Limit (Default=95) Analog throttles and digital throttles require additional programming. If a multi-position switch is selected, additional parameters must be programmed. Refer to the Troubleshooting Guide, "Multiposition Switch Setup". If an analog throttle or a digital throttle is selected, the following parameters can be programmed into the ECM.Lower Diagnostic Limit
This parameter is the minimum throttle percentage that should be detected by the ECM in normal operation when the pedal is in the "off" position. A value below this limit will generate a short circuit diagnostic code. The range of this diagnostic detection area is from 0 percent to the programmed value for the lower position limit.
Table 1
Range Default
0 to 100% 5% Lower Position Limit
This parameter is the minimum throttle percentage that will be interpreted by the ECM as zero throttle. This parameter is used with the value of initial lower position limit to make an allowance for manufacturing tolerances between different pedals.
Table 2
Range Default
0 to 100% 10% Initial Lower Position Limit
This parameter is the maximum throttle percentage that will be interpreted by the ECM as zero throttle. This parameter is used with the value of the lower position limit to make an allowance for manufacturing tolerances between different pedals.
Table 3
Range Default
0 to 100% 20% Idle Validation
All analog throttles and digital throttles can have an idle validation switch. If this parameter is programmed to "Yes", the ECM will look for this switch input on pin J1:22 for Idle Validation Switch 1 (IVS1) and J1:40 for Idle Validation Switch 2 (IVS2).
Table 4
Values Default
No
Yes No Idle Validation Minimum Off (Open) Threshold
This parameter is the minimum throttle percentage that will be detected by the ECM when the IVS is ON (Closed).If the ECM detects a throttle percentage below this value with the idle validation switch OFF (Open), a fault code will be generated and the engine will remain at idle.Refer to Table 5 and Table 6.
Table 5
Throttle Position Sensor (TPS) Idle Validation Switch (IVS) Throttle Demand Output Fault Status Comment
TPS< IVS Min OFF OFF Minimum Position Raise IVS fault Force throttle demand to minimum
TPS< IVS Min OFF ON Throttle Position No fault Normal operation
Table 6
Range Default
0 to 100% 21% Idle Validation Maximum On (Closed) Threshold
This parameter is the maximum throttle percentage that will be detected by the ECM when the idle validation switch (IVS) is OFF (Open) . When the idle validation switch is OFF (Open) and the ECM detects a signal that is higher than the programmed value for IVS Max ON, the ECM will generate a fault code and the engine will remain at idle.Refer to Table 7 and Table 8.
Table 7
Throttle Position Sensor (TPS) Idle Validation Switch (IVS) Throttle Demand Output Fault Status Comment
TPS> IVS Max ON OFF Throttle Position No fault Normal operation
TPS< IVS Min Off ON Minimum Position Raise IVS fault Force throttle demand to minimum
Table 8
Range Default
0 to 100%
Parts gasket Suzuki:
09168-10004
09168-10004 Gasket, Drain Plug
20ELB, 20ELC, 20ELN, 25ELB, 25ELC, 25ELN, 25ELT, 25ELX, DT14C, DT14D, DT14F, DT16LB, DT16LC, DT16LN, DT16LT, DT16LT, DT16LT, DT16SB, DT16SC, DT16SN, DT16ST, DT16ST, DT16ST, DT20ESB, DT20ESC, DT20ESN, DT20MLB, DT20MLC, DT20MLN, DT20MSB, DT20MSC, DT20M
09168-06002
09168-06002 Gasket, Cam Stop Screw
20ELB, 20ELC, 20ELN, 25ELB, 25ELC, 25ELN, 25ELT, 25ELX, 30ELE, 30ESE, 30MLE, DT14C, DT14D, DT14F, DT15 MLE, DT15ELD, DT15ELE, DT15ELF, DT15ELG, DT15ELH, DT15ELJ, DT15ESD, DT15ESE, DT15ESF, DT15ESG, DT15ESH, DT15ESJ, DT15MLD, DT15MLF, DT15MLG, DT15MLH
09168-25002
09168-25002 Gasket, Drain Plug
20ELB, 20ELC, 25ELB, 25ELC, DT14C, DT14D, DT16LB, DT16LC, DT16LN, DT16SB, DT16SC, DT16SN, DT20ESB, DT20ESC, DT20MLB, DT20MLC, DT20MSB, DT20MSC, DT25ESB, DT25ESC, DT25MLB, DT25MLC, DT25MSB, DT25MSC, DT5LC, DT5SC, DT7.5LB, DT7.5LC, DT7.5SB, DT7.5SC
65871-93001
65871-93001 Gasket, Fuel Gauge
20ELB, 20ELC, 20ELN, 25ELB, 25ELC, 25ELN, 25ELT, 25ELX, DT14C, DT14D, DT14F, DT16LB, DT16LC, DT16LN, DT16LT, DT16LT, DT16LT, DT16SB, DT16SC, DT16SN, DT16ST, DT16ST, DT16ST, DT20ESB, DT20ESC, DT20ESN, DT20MLB, DT20MLC, DT20MLN, DT20MSB, DT20MSC, DT20M
65561-98501
65561-98501 Gasket, Tank Cap
25ELB, 25ELC, 25ELN, 25ELT, 25ELX, DT14F, DT16LB, DT16LC, DT16LN, DT16SB, DT16SC, DT16SN, DT25ELZ, DT25ESB, DT25ESC, DT25ESN, DT25EST, DT25ESX, DT25ESZ, DT25MLB, DT25MLC, DT25MLN, DT25MLT, DT25MLX, DT25MLZ, DT25MSB, DT25MSC, DT25MSN, DT25MST, DT25MSX
13392-58600
13392-58600 Gasket, needle valve
20ELB, 20ELC, 20ELN, 25ELT, 25ELX, 30ELE, 30ESE, 30MLE, DT115, DT140, DT150SSH, DT150SSJ, DT150SSK, DT150SSL, DT150SSM, DT150SSN, DT150STCLP, DT150STCLR, DT150STCLS, DT150STCLT, DT150TCLH, DT150TCLJ, DT150TCLK, DT150TCLL, DT150TCLM, DT150TCLN, DT150T
13251-93310
13251-93310 Gasket, float chamber
20ELB, 20ELC, 20ELN, 25ELT, 25ELX, 30ELE, 30ESE, 30MLE, DT20ELG, DT20ELH, DT20ELJ, DT20ESB, DT20ESC, DT20ESG, DT20ESH, DT20ESJ, DT20ESN, DT20MLB, DT20MLC, DT20MLG, DT20MLH, DT20MLJ, DT20MLN, DT20MSB, DT20MSC, DT20MSG, DT20MSH, DT20MSJ, DT20MSN, DT25E
11141-93000
11141-93000 Gasket, Cylinder Head
20ELB, 20ELC, 20ELN, DT20ESB, DT20ESC, DT20ESN, DT20MLB, DT20MLC, DT20MLN, DT20MSB, DT20MSC, DT20MSN