13125-99E10 Suzuki GASKET, THROTTLE BODY

Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     FT-2741     Chain Assembly     1    
B     159-3327     Hex wrench     1    Start By:
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Remove the radiator and hydraulic oil cooler. Refer to Disassembly and Assembly, "Radiator and Hydraulic Oil Cooler - Remove".
Remove the air cleaner. Refer to Disassembly and Assembly, "Air Cleaner - Remove and Install".
Remove the muffler. Refer to Disassembly and Assembly, "Muffler - Remove and Install".
Tilt the cab. Refer to Disassembly and Assembly, "Cab Tilt".
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result without releasing all of the hydraulic pressure.Release all the pressure from the hydraulic system before any lines are disconnected.
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, hoses, wires, and tubes for installation purposes. Plug all lines, hoses and tubes. This helps prevent fluid loss and contamination of the fluid systems.
Open the engine access door.
Illustration 1 g00594399
Raise the cover on the negative terminal of the battery. Disconnect negative terminal (2) of the battery. Place tape on the negative terminal of the battery.
Raise the cover on the positive terminal of the battery. Disconnect positive terminal (1) of the battery. Place tape on the positive terminal of the battery.
Illustration 2 g00772986
Remove four bolts (3) and the washers. Remove cover (4) .
Illustration 3 g00773256
The machine is a 246. All models will have the same lifting eyes.
Attach tooling (A) and a suitable lifting device to the front lifting eye of the engine.
Raise the lifting device until tooling (A) has removed the weight of the engine from the front engine mount.
Illustration 4 g00773148
Remove the nut and bolt (5). Remove the washers and the mount.
Illustration 5 g00773169
The bumper has been removed in order to display the placement of the wood block.
Install a small wood block under front engine support. Lower the engine onto the wood block. Do not place the block on the bumper.