43424-99J00 Suzuki HOLDER, ADJ NUT


43424-99J00 HOLDER, ADJ NUT Suzuki DF8A, DF8AR, DF9.9A, DF9.9AR, DF99AR HOLDER
43424-99J00 HOLDER, ADJ NUT Suzuki
Rating:
18

Buy HOLDER, ADJ NUT 43424-99J00 Suzuki genuine, new aftermarket parts with delivery
Number on catalog scheme: 27
 

Compatible models:

Suzuki entire parts catalog list:

Information:

Water Temperature Regulator (Thermostat)
Replace
Replacing the water temperature regulator prior to failure is a recommended preventive maintenance practice because replacing the water temperature regulator reduces the chances for unscheduled downtime.Depending on the engine operating load, a water temperature regulator that fails in a partially opened position will cause either overheating or overcooling.If the water temperature regulator fails in the closed position, the failure will cause excessive overheating. Excessive overheating could result in cylinder head cracking or piston seizure problems.If the water temperature regulator fails in the open position, the failure will cause the engine operating temperature to be too low during partial load operation. Low engine operating temperatures during partial load operation could cause an excessive build up of carbon inside of the cylinder. This excessive build up of carbon could result in accelerated wear to the piston ring and the cylinder liner.
Failure to replace the water temperature regulator on a regularly scheduled basis could cause severe engine damage.Caterpillar engines incorporate a shunt design cooling system and require operating the engine with a water temperature regulator installed.If the water temperature regulator is installed wrong, the engine may overheat, causing cylinder head damage. Ensure that the new water temperature regulator is installed in the original position. Ensure that the water temperature regulator vent hole is open.DO NOT use liquid gasket material on the gasket or cylinder head surface.
Refer to the Service Manual for the temperature regulator replacement procedure, or consult with your Caterpillar dealer. If replacing water temperature regulators ONLY, drain the coolant from the cooling system to a level below the water temperature regulator housing.
Fill the cooling system at a rate of 19 L (5 US gal) or less per minute in order to avoid air locks.
Refer


Parts holder Suzuki:

67256-95600
 
67256-95600 Holder, neutral lock
30ELE, 30ESE, 30MLE, DF15, DF15, DF15, DF150, DF150, DF150, DF150TX, DF150ZX, DF15A, DF15S, DF175, DF175, DF175, DF175TX, DF175ZX, DF200, DF200, DF200, DF200T, DF200Z, DF20A, DF225, DF225, DF225, DF225T, DF225Z, DF25, DF25(R)S, DF250, DF250, DF250, D
38915-90J00
 
38915-90J00 HOLDER, RELAY
DF100, DF100, DF100, DF115, DF115, DF115, DF115TL, DF140, DF140, DF140, DF140T, DF140T, DF140Z, DF140Z, DF140Z, DF140Z, DF15, DF15, DF15, DF15A, DF15S, DF200, DF200, DF200, DF200T, DF200Z, DF20A, DF225, DF225, DF225, DF225T, DF225Z, DF25(R)S, DF250,
31173-94J00
 
31173-94J00 HOLDER ASSY, BRUSH
DF15, DF15, DF15, DF15A, DF15S, DF20A, DF25(R)S, DF25R, DF25R, DF40, DF40, DF40A, DF40A, DF40QH, DF40TL, DF50, DF50, DF50A, DF50A, DF50QH, DF50TL, DF60A, DF60A, DF8A, DF8AR, DF9.9, DF9.9A, DF9.9AR, DF9.9R, DF9.9RL, DF9.9S, DF9.9TH, DF9.9TH, DF99AR, D
13361-99J00
 
13361-99J00 HOLDER, CABLE
DF8A, DF8AR, DF9.9A, DF9.9AR, DF99AR
21126-99J00
 
21126-99J00 HOLDER, CLUTCH SHAFT
DF8A, DF8AR, DF9.9A, DF9.9AR, DF99AR
51110-99J00
 
51110-99J00 HOLDER, ENGINE
DF8A, DF8AR, DF9.9A, DF9.9AR, DF99AR
67340-99J00
 
67340-99J00 HOLDER, REMOCON CABLE
DF15A, DF20A, DF8A, DF8AR, DF9.9A, DF9.9AR, DF99AR
32890-99J00
 
32890-99J00 HOLDER, ELECTRIC PARTS
DF8A, DF8AR, DF9.9A, DF9.9AR, DF99AR
Back to top