56120-98J10-0EP Suzuki HOUSING, PROP SFT BRG (BLACK)


56120-98J10-0EP HOUSING, PROP SFT BRG (BLACK) Suzuki DF300, DF300 HOUSING
56120-98J10-0EP HOUSING, PROP SFT BRG (BLACK) Suzuki
Rating:
103

Buy HOUSING, PROP SFT BRG (BLACK) 56120-98J10-0EP Suzuki genuine, new aftermarket parts with delivery
Number on catalog scheme: 36
 

Compatible models:

DF300   Suzuki

Suzuki entire parts catalog list:

DF300 2007,2008,2009
DF300 2010

Information:


Table 1
Part Number Container Size Volume of Finished Coolant Produced
351-9431 3.8 L (1 US gal) 50.5 L (13.3 US gal)
351-9432 20 L (5.3 US gal) 267 L (70.5 US gal)
351-9433 208 L (55 US gal) 2773 L (733 US gal)
366-2753 (1) 1000 L (264 US gal) 13333 L (3523 US gal)
(1) NACD and LACD onlyMixing Cat ELI
The recommended water for mixing with Cat ELI concentrate is distilled or deionized water. Water must meet requirements of ASTM 1193, "Type IV Reagent Water Specification". If distilled or deionized water is not available, water should meet the “Caterpillar Minimum Acceptable Water Requirements” provided in this Special Publication.To ensure a proper concentration, the preferred method is to mix Cat ELI concentrate with water. Then, add the mixed coolant to the engine cooling system. Add the proper amounts of water and Cat ELI into a clean container and mix thoroughly by manual stirring or mechanical agitation.If the preferred method cannot be performed, a Cat ELI mixture can be made by adding Cat ELI concentrate directly into engine cooling system. Add good quality water until the dilution level is approximately 7.5%. Adequate mixing is attained by operating the engine for at least 30 minutes.Appropriate mixing rates for available ELI container sizes are provided in Table 1.After the addition of water and proper mixing, the concentration of Cat ELI can be determined using the 360-0774 Digital Brix Refractometer.Changing to Cat ELI
For cooling systems previously running Cat ELC or an extended life coolant that meets Cat EC-1 requirements, drain the cooling system and flush with water. Then refill the cooling system with a mixture of 7.5% Cat ELI in water that meets the “Caterpillar Minimum Acceptable Water Requirements”.For cooling systems previously running a conventional heavy-duty coolant or a water/SCA mixture, follow the steps listed in this Special Publication, "Changing to Cat ELC". Then refill the cooling system with a mixture of 7.5% Cat ELI in water that meets the “Caterpillar Minimum Acceptable Water Requirements”.Cat ELI Maintenance
Maintenance of Cat ELI is similar to Cat ELC. A coolant sample should be submitted for S O S Level 2 Coolant Analysis after the first 500 hours of operation and then annually thereafter.Cat ELC Extender should be added at the midpoint of service life (typically 6,000 hours), or as recommended by S O S Coolant Analysis results.Analysis and interpretation of Cat ELI S O S results is similar to the analysis and interpretation of Cat ELC. There will be no glycol and glycol oxidation products, which do not apply to Cat ELI.The concentration of a sample of in-use Cat ELI taken from the cooling system can also be determined using the 360-0774 Digital Brix Refractometer.Note: Clean water is the only flushing agent that is required when Cat ELI is drained from a properly maintained cooling system.Mixing Cat ELI and Cat ELC
Since Cat ELI and Cat ELC are based on the same corrosion inhibitor technology, Cat ELI can be mixed with Cat ELC. Mixing may be desired when only low level of freeze protection is required. Consult your local Cat dealer to ensure proper mixing of the products to provide adequate freeze protection and corrosion protection.


Parts housing Suzuki:

25141-98J00
 
25141-98J00 HOUSING, SHIFT ROD GUIDE
DF200, DF200, DF200, DF225, DF225, DF225, DF250, DF250, DF250, DF300, DF300
56130-93J00
 
56130-93J00 HOUSING, DRIVE SHAFT BRG
DF150, DF150, DF150TX, DF150ZX, DF175, DF175, DF175TX, DF175ZX, DF200, DF200, DF200T, DF200Z, DF225, DF225, DF225T, DF225Z, DF250, DF250, DF250T, DF250Z, DF300, DF300
56120-98J00-0EP
 
56120-98J00-0EP HOUSING, PROP SFT BRG (BLACK)
DF200, DF200, DF200, DF225, DF225, DF225, DF250, DF250, DF250, DF300, DF300
52111-98J00-0EP
 
52111-98J00-0EP HOUSING, DRIVE SHAFT (BLACK)
DF250A, DF300, DF300, DF300A
67211-98J20
 
67211-98J20 HOUSING
DF250A, DF300, DF300, DF300A
67211-98J00
67211-98J10
67211-98J30
 
67211-98J30 HOUSING (R)
DF250A, DF300, DF300, DF300A
Back to top