09491-29001 Suzuki Jet, Main 145


09491-29001 Jet, Main 145 Suzuki DT14C, DT14D, DT14F, DT16LB, DT16LC, DT16LN, DT16SB, DT16SC, DT16SN, DT9C, DT9D, DT9F Jet
09491-29001 Jet, Main 145 Suzuki
Rating:
103

Buy Jet, Main 145 09491-29001 Suzuki genuine, new aftermarket parts with delivery
Number on catalog scheme: 39-2
 

Suzuki entire parts catalog list:

DT14C 1977
DT14D 1978
DT14F 1979
DT16LB 1977
DT16LC 1978
DT16LN 1979
DT16SB 1977
DT16SC 1978
DT16SN 1979
DT9C 1977
DT9D 1978
DT9F 1979

Information:

Probable Causes
Switches
Batteries
Electric starting system (if equipped)
Flywheel ring gear
Driven equipment
Hydraulic cylinder lock
Worn engine componentsRecommended Actions
Table 1
Troubleshooting Test Steps Values Results
1. Inspect the Switches
A. Check the keyswitch input to the ECM.
B. Check engine shutdown switches.
C. Connect Cat® Electronic Technician (ET) to the service tool connector.
D. Use Cat ET to verify the status of the shutdown switches.
Switches
Result: The switch statuses are good.
Proceed to Test Step 2.
Result: There is a problem with a switch.
Repair: Repair or replace damaged switch.
If the problem is not resolved, proceed to Test Step 2.
2. Inspect the Batteries
A. Charge the batteries, if necessary. Refer to Testing and Adjusting , Battery - Test for additional information.
Batteries
Result: The batteries are in good condition.
Proceed to Test Step 3.
Result: There is a problem with the batteries.
Repair: Repair or replace the batteries.
If the problem is not resolved, proceed to Test Step 3.
3. Check the Electric Starting System
A. If the application is equipped with an electric starting system, perform the following procedure:
a. Check the wiring to the starting motor solenoid. Refer to the electrical schematic.
b. Check the engine start switch and the engine start relay for electrical power.
c. Check the starting motor cables. If the starting motor cables are corroded, remove the starting motor cables and clean the starting motor cables.
d. Test the operation of the starting motors.
Starter
Result: The electric starter is in good condition
Proceed to Test Step 6.
Result: There is a problem with the electric starter.
Repair: Repair or replace damaged electric starter.
If the problem is not resolved, proceed to Test Step 6.
4. Inspect the Flywheel Ring Gear for Damage
Ring Gear
Result: There is no apparent damage to the flywheel ring gear.
Proceed to Test Step 5.
Result: There is a problem with the flywheel ring gear.
Repair: Repair or replace the ring gear.
If the problem is not resolved, proceed to Test Step 5.
5. Inspect the Driven Equipment
Driven Equipment
Result: The driven equipment is in good condition.
Proceed to Test Step 6.
Result: There is a problem with the driven equipment.
Repair: Repair or replace damaged driven equipment.
If the problem is not resolved, proceed to Test Step 6.
6. Check for Hydraulic Cylinder Lock
A. If an injector has been replaced, evacuate any fluids from the cylinder and attempt to start the engine. Fuel will flow from the cylinder head into the cylinders when a unit injector is removed.
B. If the engine will not start, check for fluid in the cylinders (hydraulic cylinder lock) by removing the individual unit injectors. Check for damaged seals. Determine the type of fluid that locked up the cylinder.
C. If there was a coolant leak, determine the cause of the leak.
D. If there was excessive fuel in the cylinder, replace the seals and reinstall the injector. Drain any excess fuel from the cylinder head.
Hydraulic Cylinder Lock
Result: The engine does not have a hydraulic cylinder lock.
Proceed to Test Step 7.
Result: The engine has a hydraulic cylinder lock.
Repair: Perform the necessary repairs.
If the problem is not resolved, proceed to Test Step 7.
7. Inspect the Engine for Internal Problems
A. If a mechanical problem is suspected, disassemble the engine. Refer to the Disassembly and Assembly manual for additional information.
B. Inspect the internal components for the following conditions:
- Seizure
- Broken components
- Bent components
Damaged or Worn Engine Components
Result: There are worn or damaged engine components.
Repair: Repair or replace the worn or damaged engine components.
Verify that the repair eliminated the problem.
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).


Parts jet Suzuki:

09492-40004
Jet, Pilot 40
09492-40004 Jet, Pilot 40
DT16LB, DT16LC, DT16LN, DT16SB, DT16SC, DT16SN, DT9C, DT9D, DT9F
09491-28005
 
09491-28005 Jet, Main 140
DT14C, DT14D, DT14F, DT16LB, DT16LC, DT16LN, DT16SB, DT16SC, DT16SN, DT9C, DT9D, DT9F
09491-30004
 
09491-30004 Jet, Main 150
DT14C, DT14D, DT14F, DT16LB, DT16LC, DT16LN, DT16SB, DT16SC, DT16SN, DT9C, DT9D, DT9F
09492-35004
 
09492-35004 Jet, Pilot 35
DT14C, DT14D, DT14F
09492-45009
 
09492-45009 Jet, Pilot 45
DT14C, DT14D, DT14F
09491-31001
 
09491-31001 Jet, Main 155
DT14C, DT14D, DT14F, DT16LB, DT16LC, DT16LN, DT16SB, DT16SC, DT16SN
09491-32005
 
09491-32005 Jet, Main 160
DT14C, DT14D, DT14F, DT16LB, DT16LC, DT16LN, DT16SB, DT16SC, DT16SN
09491-27005
 
09491-27005 Jet, Main 135
DT14C, DT14D, DT14F
Back to top