61633-95204-0EP Suzuki LEVER, FRONT


61633-95204-0EP LEVER, FRONT Suzuki DT150, DT200, DT225 LEVER
61633-95204-0EP LEVER, FRONT Suzuki
Rating:
78

Buy LEVER, FRONT 61633-95204-0EP Suzuki genuine, new aftermarket parts with delivery
Number on catalog scheme: 17
 

Compatible models:

DT150   DT200   DT225   Suzuki

Suzuki entire parts catalog list:

DT150 1998,1999,2000,2001,2002,2003
DT200 1998,1999,2000,2001,2002,2003
DT225 1998,1999,2000,2001,2002,2003

Information:


Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     4C-5597     Anti-Seize Compound     -    
B     195-4609     Seal Pick     1    
C     -     Isopropyl Alcohol     -    
D     5P-4996     Plug     2    
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool.
Illustration 1 g02300314
Remove sheet assembly (1) .
Illustration 2 g02300333
Illustration 3 g02300500
Remove tube assemblies (2) and tube assembly (7). Plug the coolant lines with Tooling (D) .
Disconnect cable assembly (4) and remove spark plug (3) .
Remove flame detection sensor (8) and disconnect heated nozzle (9) .
Remove nuts (5), combustion head (6), gasket (13), tube assembly (12), and gasket (11) .Note: Gaskets are one time use. Install new gaskets upon installation.
If required, remove studs (10) .
Illustration 4 g02482996
Use Tooling (B) in order to remove O-ring seals (14) and (15) from the heated nozzle (9). Discard the O-ring seals.Installation Procedure
Install combustion head (6) in the reverse order of removal.
Apply Tooling (A) onto the threads of studs (10). Tighten studs (10) to a torque of 17 2 N m (150 18 lb in).
Apply Tooling (A) onto the threads of the studs and nuts (5). Tighten nuts (5) in a crisscross pattern to a torque of 23 3 N m (204 27 lb in). Tighten nuts (5) again in a crisscross pattern to a torque of 28 3 N m (21 2 lb ft). Tighten nuts (5) again in a crisscross pattern to a torque of 28 3 N m (21 2 lb ft).
Use caution when you are using isopropyl alcohol. Avoid prolonged skin contact with isopropyl alcohol.Vapors may be harmful if inhaled. Use only in a well ventilated area. Do not smoke while using isopropyl alcohol.Isopropyl alcohol is flammable. Do not use near an open flame or near welding operations. Keep isopropyl alcohol away from heated surfaces exceeding 482°C (900°F).
Note: This connection is an electrical connection and cannot be lubricated with a petroleum-based lubricant. Isopropyl alcohol is the only approved lubrication for this connection.
Lubricate new O-ring seals (14) and (15) with Tooling (C) prior to installation.
Apply Tooling (A) to the threads of flame detection temperature sensor (8) and install the sensor. Tighten flame detection temperature sensor (8) to a torque of 45 5 N m (33 3 lb ft).
Tighten spark plug (3) to a torque of 47 4 N m (35 3 lb ft).
Check the coolant level. If necessary, refer to Operation and Maintenance Manual, "Coolant - Change" for the proper filling procedures.
Perform the ARD ignition test. Refer to Troubleshooting Manual, "ARD Ignition - Test".


Parts lever Suzuki:

67241-95680
 
67241-95680 LEVER, FREE THROT (GRAY)
DT115, DT140, DT150, DT150SSH, DT150SSJ, DT150SSK, DT150SSL, DT150SSM, DT150SSN, DT150STCLP, DT150STCLR, DT150STCLS, DT150STCLT, DT150TCLH, DT150TCLJ, DT150TCLK, DT150TCLL, DT150TCLM, DT150TCLN, DT150TCLP, DT150TCLR, DT150TCXGM, DT150TCXGN, DT150TCXG
67257-92E00
 
67257-92E00 LEVER CAP
DF100, DF100, DF100, DF100A, DF115, DF115, DF115, DF115A, DF115TL, DF140, DF140, DF140, DF140A, DF140T, DF140T, DF140Z, DF140Z, DF140Z, DF140Z, DF15, DF15, DF15, DF150, DF150, DF150, DF150TX, DF150ZX, DF15A, DF15S, DF175, DF175, DF175, DF175TX, DF175
67283-92E50
 
67283-92E50 LEVER DECAL
DF150, DF150, DF150, DF150TX, DF150ZX, DF175, DF175, DF175, DF175TX, DF175ZX, DF200, DF200, DF200, DF200T, DF200Z, DF225, DF225, DF225, DF225T, DF225Z, DF25, DF25(R)S, DF250, DF250, DF250, DF250T, DF250Z, DF25Q, DF25Q(QR), DF25R, DF25R, DF25T, DF30,
61633-87D03-0EP
 
61633-87D03-0EP LEVER, REAR
DT150, DT200, DT225
61645-90J00-0EP
 
61645-90J00-0EP LEVER, FRONT
DT150, DT200, DT225
41220-87D01-0EP
 
41220-87D01-0EP LEVER, TILT LOCK
DT150, DT200, DT225
19122-92E00
Back to top