09250-10010 Suzuki Plug


09250-10010 Plug Suzuki DT50, DT50, DT50ECLE, DT50ELB, DT50ELC, DT50ELN, DT50ESB, DT50ESC, DT50ESN, DT50M, DT50MCLE, DT50MLC, DT50MLN, DT50MSC, DT50MSN, DT50W, DT60CLD, DT60CLE, DT65, DT65, DT65ELC, DT65ELN, DT65ESC, DT65ESN, DT75TCLD, DT75TCLE, DT75TCLF, DT85ELT, DT85TCLD, Plug
09250-10010 Plug Suzuki
Rating:
88

Buy Plug 09250-10010 Suzuki genuine, new aftermarket parts with delivery

You can buy parts:

As an associate, we earn commssions on qualifying purchases through the links below
$1.67
 

27-09-2019

-: -
Suzuki Cap 09250-10010 New Oem
New OEM Suzuki Cap || OEM Part Number: 09250-10010 || Item only fits specific models listed. The picture could be generic. || Message us with VIN/HULL for fast fitment verification.
Number on catalog scheme: 41
 

Suzuki entire parts catalog list:

DT50 1980,1981,1982
DT50 1983
DT50ECLE 1984
DT50ELB 1977
DT50ELC 1978
DT50ELN 1979
DT50ESB 1977
DT50ESC 1978
DT50ESN 1979
DT50M 1980,1981,1982
DT50MCLE 1984
DT50MLC 1978
DT50MLN 1979
DT50MSC 1978
DT50MSN 1979
DT50W 1980,1981,1982
DT60CLD 1983
DT60CLE 1984
DT65 1980,1980,1981,1981,1982,1982
DT65 1980,1980,1981,1981,1982,1982
DT65ELC 1978
DT65ELN 1979
DT65ESC 1978
DT65ESN 1979
DT75TCLD 1983
DT75TCLE 1984
DT75TCLF 1985
DT85ELT 1980
DT85TCLD 1983
DT85TCLE 1984
DT85TCLF 1985
DT85TCLT 1980
DT85TCLX 1981
DT85TCLZ 1982
DT85TELN 1979
DT85TELT 1980

Information:


Table 1
Associated Code
J1939 Code Description
5580-17 Engine Filtered Fuel Delivery Pressure (After Secondary Filter Gauge): Low - least severity (1)
5580-18 Engine Filtered Fuel Delivery Pressure (After Secondary Filter Gauge): Low - moderate severity (2)
1664-31 Engine Automatic Start Failed Probable Causes
Note: If the engine will not start and Cat ET will not communicate, the problem is most likely with the electrical power supply to the ECM. Refer to Troubleshooting, "Electrical Power Supply - Test".Fuel Supply System
Low fuel levelEngine Shutdown Switches (if applicable)
Engine shutdown switchesStarting Aids (if applicable)
Starting aidsRestrictions in the Air Inlet and Exhaust System
Restriction in the air inlet and exhaust systemTheft Deterrent System (if applicable)
Active theft deterrent systemSensors
Coolant temperature sensor
Atmospheric pressure sensor Engine Speed/Timing
Engine speed/timing sensorFuel System
Low-pressure fuel system Recommended Actions
Note: The procedures have been listed in order of probability. Complete the procedures in order.Low Fuel Level
Visually check the fuel level in the fuel tank. Do not rely on the fuel gauge only.
Ensure that the fuel supply valve (if equipped) is in the full OPEN position. Engine Shutdown Switches (if applicable)
The engine shutdown switches must be in the OFF position. Use Cat ET to verify the status of the engine shutdown switches. When an engine shutdown switch is used to shut down the engine, electrical power must be removed from the ECM for at least 15 seconds before restarting the engine.Starting Aids (if applicable)
If cold ambient conditions exist, check the operation of the starting aids. Verify that the starting aid is operating correctly. Refer to the appropriate circuit test in order to troubleshoot the starting aid.Restriction in the Air Inlet and Exhaust System
Check for an air filter restriction indicator. Replace plugged air filters. Refer to the Operation and Maintenance Manual for the correct procedure.
Check the air inlet and exhaust system for restrictions and/or leaks. Refer to Systems Operation/Testing and Adjusting, "Air Inlet and Exhaust System" for additional information. Active Theft Deterrent System (if applicable)
Verify that the theft deterrent system is not active.Coolant Temperature Sensor and Atmospheric Pressure Sensor
Use Cat ET to check the output signals of the sensors. The coolant temperature sensor must provide a correct signal in order for cold mode operation to operate correctly. Verify that the coolant temperature on Cat ET is reasonable for the conditions that are present.The atmospheric pressure sensor is used to provide calibrations for the other pressure sensors that are on the engine. Verify that the sensor is reading the correct barometric pressure for the conditions that are present.Engine Speed/Timing
Crank the engine and observe the engine speed on the Cat ET status screen. Refer to Troubleshooting, "Speed/Timing - Test" for additional information.Note: Upon initial cranking, the status for engine speed may indicate that the engine speed signal is abnormal. This message will be replaced with an engine speed once the ECM is able to calculate a speed from the signal.Low Pressure Fuel System
Inspect the fuel system. Refer to Systems Operation/Testing and Adjusting, "Fuel System" for additional information.
Cold weather adversely affects the characteristics of the fuel. Refer to the Operation and Maintenance Manual for information on improving the characteristics of the fuel during cold-weather operation.
Check fuel quality. Check the fuel tank for debris or foreign objects which may block the fuel supply.
Check the filtered fuel pressure while the engine is being cranked. Refer to Systems Operation/Testing and Adjusting, "Fuel System" for the test procedure and for the correct pressure values. If the fuel pressure is low, replace the fuel filters. Clean the primary filter/water separator of debris. Refer to the Operation and Maintenance Manual for details. Also, check for the proper operation of the fuel transfer pump. Refer to Systems Operation/Testing and Adjusting, "Fuel System" for test information.


Parts plug Suzuki:

09248-10003
 
09248-10003 Plug, Drain
20ELB, 20ELC, 20ELN, 25ELB, 25ELC, 25ELN, 25ELT, 25ELX, DT14C, DT14D, DT14F, DT16LB, DT16LC, DT16LN, DT16LT, DT16LT, DT16LT, DT16SB, DT16SC, DT16SN, DT16ST, DT16ST, DT16ST, DT20ESB, DT20ESC, DT20ESN, DT20MLB, DT20MLC, DT20MLN, DT20MSB, DT20MSC, DT20M
37101-93301
 
37101-93301 Plug, Lower Cover
20ELB, 20ELC, 20ELN, 25ELB, 25ELC, 25ELN, 25ELT, 25ELX, DT20ESB, DT20ESC, DT20ESN, DT20MLB, DT20MLC, DT20MLN, DT20MSB, DT20MSC, DT20MSN, DT25ELZ, DT25ESB, DT25ESC, DT25ESN, DT25EST, DT25ESX, DT25ESZ, DT25MLB, DT25MLC, DT25MLN, DT25MLT, DT25MLX, DT25M
65720-98501
Plug Assembly, Fuel Connector
65720-98501 Plug Assembly, Fuel Connector
25ELT, 25ELX, DT14C, DT14D, DT14F, DT25ELZ, DT25EST, DT25ESX, DT25ESZ, DT25MLT, DT25MLX, DT25MLZ, DT25MST, DT25MSX, DT25MSZ, DT28G, DT28J, DT28Z, DT3.5LN, DT3.5LT, DT3.5LX, DT3.5LZ, DT3.5SN, DT3.5ST, DT3.5SX, DT3.5SZ, DT50, DT50M, DT50W, DT5LC, DT5LN
09248-10004
 
09248-10004 Plug, drain
25ELT, 25ELX, 30ELE, 30ESE, 30MLE, DT15 MLE, DT15ELD, DT15ELE, DT15ELF, DT15ESD, DT15ESE, DT15ESF, DT15MLD, DT15MLF, DT15MSD, DT15MSE, DT15MSF, DT16LT, DT16LT, DT16LT, DT16ST, DT16ST, DT16ST, DT25ELZ, DT25EST, DT25ESX, DT25ESZ, DT25MLT, DT25MLX, DT25
65720-98502
Plug, Fuel Connector
65720-98502 Plug, Fuel Connector
25ELT, 25ELX, DT16LT, DT16LT, DT16LT, DT16ST, DT16ST, DT16ST, DT25ELZ, DT25EST, DT25ESX, DT25ESZ, DT25MLT, DT25MLX, DT25MLZ, DT25MST, DT25MSX, DT25MSZ, DT28G, DT28J, DT28Z, DT3.5LN, DT3.5LT, DT3.5LX, DT3.5LZ, DT3.5SN, DT3.5ST, DT3.5SX, DT3.5SZ, DT35E
65720-95500
Plug, fuel connector, Brass
65720-95500 Plug, fuel connector, Brass
DT85ELT, DT85TCLT, DT85TCLX, DT85TCLZ, DT85TELN, DT85TELT
65720-95510
 
65720-95510 Plug, fuel connector, Stainless steel
DT85ELT, DT85TCLT, DT85TCLX, DT85TCLZ, DT85TELN, DT85TELT
65720-98511
 
65720-98511 Plug, Connector
25ELT, 25ELX, DT16LT, DT16LT, DT16ST, DT16ST, DT25ELZ, DT25EST, DT25ESX, DT25ESZ, DT25MLT, DT25MLX, DT25MLZ, DT25MST, DT25MSX, DT25MSZ, DT28G, DT28J, DT28Z, DT35ELT, DT35ELX, DT35ELZ, DT35EST, DT35ESX, DT35ESZ, DT35MLT, DT35MLX, DT35MLZ, DT35MST, DT3
Back to top