18100-98600 Suzuki Starter Assembly, Recoil

Illustration 1 g06500003
User Settings
(1) Settings IconCylinders - Allows customer to select between the 3600-6, 3600-8 or 3600-12 Engine.Max High Idle - Allows customer to disable high idle button on speed control speed.Power Save Enabled - Enables the display to turn off keyswitch to the engine after the programmable Power Save Timeout is reached, if the engine is in the stop position with no speed detected. The feature helps conserve battery power after a shutdown. During the Power Save State, the display will be blank. To turn the engine/display back on, the user must touch the screen.The "Settings" icon (1) allows the user to access the menu of items that are available for configuring and adjusting. The following screens are available in the General Settings Menu:
English or Metric Unit Selection
Brightness Level Adjustment
Set Time and Date
Technician Login
Display IP Configuration
Debug Log
Electronic High Idle Switch
Modbus Output Toggle
Day/Night Mode Selection
Access to Engine Configuration Settings
Access to Engine Monitoring System Settings
Snapshots
HistogramsUse the arrow keys to navigate between display screens for more information about engine or module serial numbers and installed software part numbers.
Engine Information
HMI Display InformationTechnician Login
The technician login Icon will allow the user access to the following:
Configurable Settings
Programmable Engine Monitoring Settings
Service Tests
Illustration 2 g06406173The default password is:
1800228The user can change the default password.Note: If the new user password is forgotten, use 1800228 as a password to regain access.After the Technician Login information and password is accepted, the ability to configure HMI settings will become available.Display IP
The Display IP Configuration Icon allows the user to configure the TCP/IP Modbus IP slave address.System Log
System log screen allows the user to pull system logs from the display and send the logs to developers for troubleshooting help with potential issues.Configuration
The Configuration icon provides information found within the Engine ECM configuration settings.
Timing Control
Speed Control
Gaseous Fuel Parameters
Governor Gain Parameters
Engine State Control 1
Engine State Control 2
Monitoring Parameters
Illustration 3 g06500607Configuration files can be imported to or exported from the display.Perform the following steps to import or export Configuration files from the display.
Insert USB on the back of the display.The configuration that is in the display appears on the left side. If there is a configuration on the USB, that configuration appears on the right side of the screen.
Select the desired configuration and copy to the USB to export.
Select the desired configuration and copy to the display to import.
Select the configuration and select "Apply Config" to apply the new configuration.Monitor System
The Monitoring System Icon allows the user to view the settings found within the engine ECM monitoring system settings. The Engine Monitoring System interface allows the user to navigate between various monitoring system parameters and adjust the set points if allowed. Some set points may be changed in accordance with the engine software operating requirements. Other monitoring system parameters may be non-configurable and for viewing only. Within this menu you may find:
System Voltage
Engine Coolant Temp
Engine Oil Pressure
Engine Oil Temp
Engine Oil to Engine Coolant Temp Diff
Oil Filter Diff Pressure
High Gaseous Fuel Quality Value
Low Gaseous Fuel Quality Value
Fuel Temp
Low Fuel Pressure
High Fuel Pressure
High Ignition Transformer Sec Output
High Inlet Air Temp At Low Load
High Inlet Air Temp At High Load
High Engine Load
Engine Overspeed
High Fuel Rail #1 Pressure Leak
High Hydraulic Oil Pressure
High Crankcase Pressure
Low Jacket Water Pressure
High Air Inlet Diff Pressure
Low Gas Fuel Differential Pressure
Illustration 4 g06500010
Monitor System
Illustration 5 g06500013
Monitor System