13552-98411 Suzuki Pipe, Throttle Rod

Table 1
Required Tools
Tool Part Number Part Description Qty
A 370-8376 Fuel System Parts Kit 1
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorized personnel that have the correct training.Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information. Refer to System Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
When the fuel pressure relief valve is removed, a new fuel pressure relief valve must be installed.
Illustration 1 g03692123
Typical example.
Breather hose removed for clarity.
Thoroughly clean the area around fuel manifold (1) and fuel pressure relief valve (2).
Follow Step 3.a through Step 3.c in order to remove fuel pressure relief valve (2) from fuel manifold (1).
Ensure that the area around the fuel pressure relief valve (2) and fuel manifold (1) is still thoroughly clean.
Remove fuel pressure relief valve (2) from fuel manifold (1).
Immediately use tooling (A) to cap the open port in fuel manifold (1).
Discard fuel pressure relief valve (2). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 370-8376 Fuel System Parts Kit 1
B - Bosch Grease Ft1v27 1
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorized personnel that have the correct training.Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information. Refer to System Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Illustration 2 g03692712
Remove the cap from the port in fuel manifold (1).
Immediately clean the threads in fuel manifold (1) for fuel pressure relief valve (2). Ensure that the thread is clean and free from debris. Ensure that the thread in the fuel manifold (1) is free from damage.
Immediately use Tooling (A) to cap the open port in fuel manifold (2) after cleaning and inspection.
Remove the cap from the threaded end of the new fuel pressure relief valve (1). Lightly lubricate the thread and bite edge (3) of the pressure relief valve with Tooling (B).
Inspect the O-ring seal on the new fuel pressure relief valve (3) for damage. Replace the fuel pressure relief valve as an assembly if the O-ring seal is damaged.
Remove the cap from the port of fuel manifold (1). Install fuel pressure relief valve (2) into fuel manifold (1) hand tight.
Tighten fuel pressure relief valve (1) to a torque of 100 N m (74 lb ft).
Clean excessive Tooling (B) from fuel pressure relief valve (2) and fuel manifold (1).
Clean the gasket surfaces of the inlet connection (1) and the inlet manifold. End By:
Install the fuel filter base. Refer to Disassembly and Assembly, "Fuel Filter Base - Remove and Install" for the correct procedure.
Remove the air from the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime" for the correct procedure.