921722-0306 Tohatsu SCREW


921722-0306 SCREW Tohatsu M25C3, M30A4, M40C, M60C, M70C, MD115A2, MD40A, MD40B, MD40B, MD40B2, MD40B2, MD50A, MD50B, MD50B, MD50B, MD50B2, MD50B2, MD70B, MD70B, MD70B, MD75C2, MD90B, MD90B, MD90B, MD90C2 SCREW
921722-0306 SCREW Tohatsu
Rating:
88

Buy SCREW 921722-0306 Tohatsu genuine, new aftermarket parts with delivery
Number on catalog scheme: 1-7
 

Tohatsu entire parts catalog list:

M25C3 2003,2005
M30A4 2003
M40C 2004
M60C 2003
M70C 2003
MD115A2 2010,2012,2013,2014
MD40A 2003
MD40B 2003,2004,2005,2007,2008,2009,2010,2011
MD40B 2006
MD40B2 2010
MD40B2 2011,2012,2013,2014
MD50A 2003
MD50B 2003
MD50B 2004,2005,2007,2008,2009,2010,2011
MD50B 2006
MD50B2 2010
MD50B2 2011,2012,2013,2014
MD70B 2003,2004,2005,2007,2008,2009
MD70B 2006
MD70B 2010
MD75C2 2010,2011,2012,2013,2014
MD90B 2003,2004,2005,2007,2008,2009
MD90B 2006
MD90B 2010
MD90C2 2010,2011,2012,2013,2014

Information:


Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Turn the fuel supply valve to the OFF position before performing this maintenance. Place a tray under the fuel filter in order to catch any fuel that might spill. Clean up any spilled fuel immediately.
Turn the fuel supply valve to the OFF position. Place a tray under the fuel filter in order to catch any fuel that might spill. Clean up any spilled fuel immediately.
Clean the outside of the fuel filter assembly.
Illustration 1 g00803020
Loosen the drain valve (3) at the bottom of the fuel filter (2). Drain the fuel into a suitable container.
Loosen and remove the old fuel filter (2) from the fuel filter base (1). Dispose of the element properly.Note: Replacement fuel filters have an inner seal assembly. The seal is held into position by a plastic clip. Damage to the fuel injection pump may occur if the seals are not installed correctly.
Lightly lubricate the two O-ring seals of the new fuel filter assembly (2) with clean diesel fuel.
Install the new fuel filter assembly (2) to the fuel filter base (1). Tighten 1/2 of a turn to 3/4 of a turn past hand tightening.
Prime the fuel system. Refer to the Operation and Maintenance Manual, "Fuel System-Prime" for more information. 3056 Marine Engine
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Turn the fuel supply valve to the OFF position. Place a tray under the fuel filter in order to catch any fuel that might spill. Clean up any spilled fuel immediately.
Clean the outside of the fuel filter assembly. Note: Both of the fuel filter elements need to be replaced at the same time if the engine is equipped with two fuel filter elements.
Illustration 2 g00749869
Hold the bottom cover (4) of the filter assembly. Remove the bolt (1) from the center of the element.
Lower the bottom cover (4) .
Remove the fuel filter element (3) and dispose of the elements properly.
Clean the inside surfaces of the fuel filter base (2). Clean the bottom cover (4) .
Replace the O-ring on the fuel filter base (2). Replace the O-ring on the bottom cover (4) .
Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.
Insert bottom cover (4) onto new element (3). Ensure that the element is installed properly to the bottom cover (4). Place the element (3) to the fuel filter base (2). Install the bolt (1) .
Prime the fuel system. Refer to the Operation and Maintenance Manual, "Fuel System-Prime" for more information.


Parts screw Tohatsu:

921503-0612
SCREW
921503-0612 SCREW
M2.5A, M2.5A2, M25C3, M3.5A2, M3.5B2, M30A4, M4C, M5B, M5BS, M8B, M9.8B, MFS2.5B, MFS2.5B, MFS2.5B, MFS2B, MFS3.5B, MFS3.5B, MFS3.5B, MFS4A2, MFS4B, MFS4B, MFS5A2, MFS5B, MFS5B, MFS6A2, MFS6B, MFS6B, MFS8A3, MFS8A3, MFS8A3, MFS9.8A3, MFS9.8A3, MFS9.8
910103-0612
SCREW, MOTOR COVER
910103-0612 SCREW, MOTOR COVER
M115A2, M15D2, M18E2, M2.5A, M25C3, M30A4, M40C, M40D2, M40D2, M40D2, M50D2, M9.9D2, MD115A, MD115A2, MD40B2, MD40B2, MD50A, MD50B2, MD50B2, MFS2.5B, MFS2.5B, MFS2.5B, MFS25A, MFS25B, MFS25B, MFS25B, MFS2B, MFS3.5B, MFS3.5B, MFS3.5B, MFS30A, MFS30B,
921503-5612
 
921503-5612 SCREW
M115A2, M120A2, M140A2, M40D2, M40D2, M40D2, M50D2, M60C, M70C, MD115A, MD115A2, MD40A, MD40B, MD40B, MD40B2, MD40B2, MD50A, MD50B, MD50B, MD50B, MD50B2, MD50B2, MD70B, MD70B, MD70B, MD90B, MD90B, MD90B, MFS25A, MFS25B, MFS25B, MFS25B, MFS30A, MFS30B
921521-6510
 
921521-6510 SCREW
M15D2, M18E2, M25C3, M30A4, M40C, M9.9D2
921503-0620
 
921503-0620 SCREW
M25C3, M30A4
921503-7625
 
921503-7625 SCREW
M40D2, M40D2, M40D2, M50D2, M60C, M70C
922531-6414
 
922531-6414 SCREW
M115A2, MD115A, MD115A2, MD40A, MD40B, MD40B, MD40B2, MD40B2, MD50A, MD50B, MD50B, MD50B, MD50B2, MD50B2, MD70B, MD70B, MD70B, MD75C2, MD90B, MD90B, MD90B, MD90C2
921503-0408
 
921503-0408 SCREW
M115A2, M40C, MD115A, MD115A2, MD40A, MD40B, MD40B, MD40B2, MD40B2, MD50A, MD50B, MD50B, MD50B, MD50B2, MD50B2, MD70B, MD70B, MD70B, MD75C2, MD90B, MD90B, MD90B, MD90C2, MFS15C, MFS15C, MFS20C, MFS20C, MFS25B, MFS25B, MFS30B, MFS8A3, MFS8A3, MFS8A3,
Back to top