3580491 Volvo.Penta Adjusting washer

21Jun2016
(Revised 30May2018)
U-322
After Failure Only
PRODUCT SUPPORT PROGRAM FOR REPLACING THE ENGINE HARNESS ON CERTAIN C7.1 (XQ200) GENERATOR SETS
1403 PS53239
Caterpillar’s obligations under this Service Letter are subject to, and shall not apply in contravention of, the laws, rules, regulations, directives, ordinances, orders, or statutes of the United States, or of any other applicable jurisdiction, without recourse or liability with respect to Caterpillar.
This Program can only be administered after a failure occurs.The decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS53239" as the Part Numberand "7755" as the Group Number. Use "96" as the Warranty Claim Description Code and use "Z" as the SIMS Description Code.
The information supplied in this service letter may not be valid after the termination date of this program.Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst.
This Revised Service Letter replaces the 21Jun2016 (Revised 08Sep2016) Service Letter. Changes have been made to the Termination Date and Affected Product.
TERMINATION DATE
31Dec2018
PROBLEM
The existing engine harness can fail pin number 2 at bulkhead connector that provides power to control on certain C7.1 (XQ200) Generator Sets.
AFFECTED PRODUCT
Model Identification Number
C7.1 MRP00100-00127, 129-583, 603-627, 629-791, 796-806
PARTS NEEDED
Qty
Part Number Description
4 3E4304 INSERT-THREADED
1 4977849 HARNESS AS
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 1% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.
A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.
Safety precautions and warnings are provided in this instruction, on the product, and in this product's Operation and Maintenance Manual (OMM). If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.
Therefore, the warnings in this publication, the warnings that are on the product, and the warnings that are in the OMM are not all inclusive. If a tool, a procedure, a work method, or operating technique that is not recommended by Caterpillar is used, the user must ensure that it is safe for the user and for other people to use.
The user should ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance, or the repair procedures that are used.
: The generator set must be isolated electrically before and while the rework is performed. Follow the proper lockout tag out procedures to protect against the unexpected energizing or startup of the generator set. Failure to follow these warnings could result in injury to personnel during service. Attach a "Do Not Operate" warning tag to the machine start switch or the controls before you perform any service to the machine.
Refer to the attached Rework Procedure.
SERVICE CLAIM ALLOWANCES