834625 Volvo.Penta Alternator, alternator and installation comps

Introduction
Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Reference Section
Reference: Specifications, SENR3130, "Torque Specifications"Reference: Refer to Disassembly and Assembly, UENR1113, "797F Off-Highway Truck" for removing any machine components to access the engine.Reference: Operation and Maintenance Manual, SEBU8417, "797F and 797F Xq Off-Highway Trucks", "Prepare the Machine for Maintenance"Caterpillar Channel 1 Video
Illustration 1 g06471531Reference: For supplemental information and interpretation of Visual Service Procedures, refer to the following video. The previous training has been replaced with the video below.Note: Click or copy the following link into a web browser (a CWS login is required to access Caterpillar Channel1), or scan the following QR code using a QR enabled device.
Illustration 2 g06306276https://channel1.mediaspace.kaltura.com/media/Introduction+to+Visualization+Service+Procedures+%28VSP%29/1_92vjr92v
Safety Section
Do not perform any procedure in this Special Instruction until you have read this Special Instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person must also have the necessary training, skills, and tools to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance of a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Avoid using a tool, a procedure, a work method, or operating technique that is not recommended by Caterpillar.Ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance, or the repair procedures.
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Personal injury or death can result from sudden movement.Prevent possible injury by performing the following procedures before work begins:Move the product or equipment to a smooth, level surface.When applicable, lower equipment/work tools to the ground.Engage the parking brake, system brakes and/or hydraulic lockout control. When applicable, stop the engine and remove the ignition key.Release system pressure from pressurized systems.If applicable, block the wheels/tracks.Turn the battery disconnect switch to the OFF position and if applicable, remove the battery disconnect key. If not equipped with a battery disconnect switch, disconnect the battery cables from the battery and tape the battery clamps. Attach a “Do Not Operate” or similar warning tag at the battery disconnect switch location and as defined by site rules and/or local regulations.
Illustration 3 g06276183
Access to this service point may require climbing on the equipment. Slipping or falling while climbing on the equipment could result in personal injury or death. Refer to the Operation and Maintenance Manual, Mounting and Dismounting topic for safety information.
Visual Service Procedure Colors
Note: Based on SAE J2892 Surface Vehicle Recommended Practice.Graphic Color Description
Color-coding of targeted components, or sections of a par