20585546 Volvo.Penta Brace, left

start by: a) remove hoodb) remove counterweight1. Remove the coolant from the cooling system.2. Remove the oil from the transmission and bevel gear case.3. Remove the oil from the flywheel clutch.4. Turn the fuel supply valve to the "OFF" position. 5. Remove the junction blocks (1) from each side of the machine.6. Put a mark on the hoses, as to their position on the junction block on the right side of the machine. 7. Remove the side covers (4) from each side of the machine.8. Remove the radiator lower and upper hoses (2) and fan guards (3).9. Remove the six bolts that hold fan and hub to the fan drive and put the fan in the radiator guard. 10. Remove bracket (5), one on each side of the machine. 11. Remove oil lines (8) and battery cable.12. Disconnect wires (6) from starter.13. Remove battery cable (9) and fuel line (7).14. Disconnect the control rods for the steering clutches from the dash and the brake pedal support. 15. Remove the oil lines (11) from the flywheel clutch.16. Disconnect interlock control (10) and remove transmission vent line. 17. Disconnect battery ground cable (13) and flywheel clutch control rod (12).18. Remove universal joint. See REMOVE UNIVERSAL JOINT.19. Remove the four bolts, two on each side of machine, that hold the flywheel housing to the frame. 20. Remove two bolts (14), one on each side of machine, that hold the engine front support to the frame.21. Install tool (A) in the hole in the front of the cylinder head. 22. Install a chain around the brackets for the dash as shown. 23. Fasten a hoist to the chain (15) and eyebolt (16). Use a spreader bar in the chain to prevent damage to the turbocharger. Remove the engine (18), dash (17) and flywheel clutch as a unit. Weight of unit is 2900 lb. (1338.1 kg).Install Engine And Flywheel Clutch (Special Application & Direct Drive)
1. Fasten a hoist to the engine. Weight of the engine is 2900 lb. (1338.1 kg). 2. Put the engine (1) in position over the tractor.3. Put the clutch lever over the shaft. As the engine is being lowered, the key of the shaft will be in alignment with the lever. Push the shaft into position. 4. Install the rod (2) into the lever. Install the washer, lock washer, and nut. Tighten the nut to a torque of 18 5 lb.ft. (2.5 0.7 mkg). Lower the engine into the tractor all of the way.
Do not cause damage to hydraulic hose when engine is being put into position.
5. Install the two bolts that hold the engine in position in the front.6. Install the four bolts that hold the engine in position at the rear. 7. Install fuel line (3) and turn fuel supply valve to "ON" position.8. Connect the hose to the hydraulic pump. 9. Install a bracket (4) to each side of the tractor. 10. Install the four hydraulic lines (6) to the transmission.11. Install the vent tube.12. Install universal joint. See INSTALL UNIVERSAL JOINT.13. Connect rods (5) to steering clutch levers.14. Connect the battery ground cable.15. Connect the flywheel clutch control.16. Connect the wires and battery cable to the starter.17. Connect the upper and lower hoses to the radiator.18. Install the fan and fan guards.19. Install the junction boxes and the hydraulic lines.20. Fill the cooling system with coolant to the correct level. See LUBRICATION AND MAINTENANCE GUIDE.21. Fill the transmission and bevel gear case with oil to the correct level. See LUBRICATION AND MAINTENANCE GUIDE.end by: a) install counterweightb) install hood