835644 Volvo.Penta Bracket

Drain the Engine Oil
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Ensure that the engine is stopped before performing this procedure. Attach a DO NOT OPERATE tag to the starting controls.
Do not drain the oil when the engine is cold. As the oil cools, suspended waste particles settle on the bottom of the oil pan. The waste particles are not removed when the cold oil is drained. Drain the crankcase with the oil warm. This draining method allows the waste particles that are suspended in the oil to be drained properly.Failure to follow this recommended procedure will allow the waste particles to be recirculated through the engine lubrication system with the new oil.
After the engine has been operated at normal operating temperature, STOP the engine.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00745694
Open drain valve (1) in order to drain used oil. After the oil has drained, close drain valve (1) .If a suction device is used to drain the oil, ensure that the suction device is clean in order to prevent dirt from entering the oil pan. Be careful not to strike the engine oil suction tubes or the piston cooling jets.Note: After the used oil has been drained and before the new oil is added, clean the oil suction screen. Replace the engine oil filter elements.Clean the Oil Suction Screen
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Clean the oil suction screen at every oil change. Clean the oil suction screen after the oil sump has been drained.Note: Approximately 1 L (1 qt) of oil will remain in the housing after the sump has been completely drained. This oil will pour out of the housing when cover (1) is removed. Catch the oil with a pan. Clean up any spilled oil with absorbent pillows or towels. DO NOT use absorbent particles to clean up the oil.
Illustration 2 g00701472
Remove the bolts and washers from cover (1). Remove cover (1) and the O-ring seal. Inspect the seal for good condition. If the seal is cut, scratched, or cracked, obtain a new seal for assembly.
Illustration 3 g00745695
Slide screen assembly (2) from the tube.
Wash screen assembly (2) in clean nonflammable solvent. Allow the screen assembly to dry before installation.
Install screen assembly (2). Install cover (1) and the O-ring seal. Secure the cover with the bolts and washers.Replace the Engine Oil filters
Replace the engine oil filters for any of the following occurrences:
Every oil change
The engine oil filter differential pressure reaches 100 kPa (15 psi).Service tools are available to aid in the service of oil filters and fuel filters. Consult your Caterpillar dealer for the part names and the part numbers. Follow the instructions that are supplied with the service tools. If the service tools are not used, perform the following procedure.
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Perform the following procedure after the oil sump has been drained.
Illustration 4 g00745696
Connect a hose from each drain valve (1) to a suitable container in order to catch the oil.
Open both drain valves (1). Allow the oil to drain.Note: Some oil will remain in the housing after the oil has been drained. This oil will pour out of the housing when cover (2) is removed. Catch the oil with a pan. Clean up any spilled oil with absorbent pillows or towels. DO NOT use absorbent particles to clean up the oil.
Personal injury can result from parts and/or covers under spring pressure.Spring force will be released when covers are removed.Be prepared to hold spring loaded covers as the bolts are loosened.