846595 Volvo.Penta Connecting pipe

Introduction
This Special Instruction provides information on parts and procedures that are required to remove and install the engine system on a 302.7D CR Mini Hydraulic Excavator.Important Safety Information
Do not perform any procedure in this special instruction until you have read this Special Instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive.
Do not attempt to assemble this machine until you read and you understand the assembly instructions.Improper assembly procedures could result in injury or death.
Personal injury or death can result from improper lifting or blocking.When a hoist or jack is used to lift any part or component, stand clear of the area. Be sure the hoist or jack has the correct capacity to lift a component. Install blocks or stands before performance of any work under a heavy component.Approximate weights of the components are shown. Clean all surfaces where parts are to be installed.
Failure to comply to the rated load can cause possible personal injury or attachment damage.Review the rated load of a particular attachment before performing any operation. Make adjustments to the rated load as necessary.
Do not leave the controls unattended while a load is suspended. No person shall be permitted to stand or pass under a suspended load or work tool. A suspended load or work tool may fall causing injury or death.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.Use removed screws again for assembly, unless there are specific instructions requiring the use of new screws, washers, and so on. Carefully store all screws that have been removed.
Required Parts
Table 1
Qty    Part Number    Description    
1     447-2825     Engine    
1     372-7340     Fuel Pump    
1     386-0617     Water Separator    
1     379-2575     Collar    
1     379-2589     Bracket    
4     379-2580     Collar    
1     379-2645     Expansion Tank    
1     372-7326     Diode    
1     384-2372     Relay    
1     379-2653     Relay    
1