849971 Volvo.Penta Drain plug

Parameter Descriptions
Injector Codes
Note: The injector codes are not part of the "Configuration" screen on Cat ET. "Injector Codes Calibration" can be found under "Calibrations" in the "Service" menu on Cat ET.The injector code is a number that is found on each of the unit injectors. The ECM uses this number to compensate for manufacturing variations between individual injectors. If you replace any of the unit injectors, you must reprogram the code for the new injectors. Also, if you replace the ECM, you must reprogram all of the injector codes."Equipment ID"
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field."Engine Serial Number"
The "Engine Serial Number" should be programmed in order to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM."Full Load Setting" (FLS)
"Full Load Setting" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information ratings plate. This value should only be changed if the engine is rerated or a new ECM is installed. Factory passwords are required."Full Torque Setting" (FTS)
"Full Torque Setting" is similar to "Full Load Setting". This value should only be changed if the engine is rerated or a new ECM is installed. Factory passwords are required."Ether Control"
The "Ether Control" parameter allows the operation of this feature to be enabled or disabled.System Configuration Parameters
Table 1
System Configuration Parameters    
Parameter    Available Range or Options    Default    Required Password    
"Equipment ID"     17 characters     blank     none    
"Engine Serial Number"     8 characters     blank     Factory    
"FLS"     -128 to +127     0     Factory    
"FTS"     -128 to +127     0     Factory    
"Ether Control"     "Enable" or "Disable"     "Disable"     none    Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters    
"Equipment ID"    
   
"Engine Serial Number"    
   
"ECM Serial Number"    
   
"Personality Module Part Number"    
   
"Personality Module Release Date"    
   
"Personality Module Description"    
   
"FLS"    
   
"FTS"    
   
"Fuel Ratio Control Offset"    
   
"Ether Control"    
   
"Total Tattletale"    
   
Injector Code (1)    
   
Injector Code (2)    
   
Injector Code (3)    
   
Injector Code (4)    
   
Injector Code (5)    
   
Injector Code (6)    
   
Table 3
Information From Engine Information Plate    
Engine Serial Number    
   
Full Load Setting (for new ECM)    
   
Full Torque Setting (for new ECM)    
   Note: Compare the FLS and the FTS from the ECM with the values that are listed on the Engine Information Plate. The FLS and the FTS should only be changed because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine.