3832462 Volvo.Penta Fan shroud

Table 1
Required Tools
Tool Part Number Part Description Qty
A 130-2534 Bridge Dowel Gauge 1
B 8T-2998 Lubricant - Start By:
Remove the valve cover base.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01313992
Remove the bolts that hold rocker arm assembly (2). Remove rocker arm assembly (2). Place identification marks on the rocker arm assembly so that the rocker arm assembly can be installed in the same location.
Place identification marks on pushrods (1) for assembly purposes and remove pushrods (1).
Remove valve bridges (3). Identify the location of each valve bridge so that the valve bridges can be installed in the same location.
Inspect the bore of each valve bridge for roughness or wear. Be sure that the passage for lubrication in the valve bridge is not restricted.
Inspect bridge dowels (4) for roughness or wear. If removal of the bridge dowel is necessary, refer to Disassembly and Assembly, "Cylinder Head - Disassemble". Installation Procedure
Illustration 2 g01313992
Use Tooling (A) to be sure that bridge dowels (4) are straight and installed to a height of 105.00 2.00 mm (4.100 0.080 inch) above the surface of the cylinder head. If installation of the bridge dowels is necessary, refer to Disassembly and Assembly, "Cylinder Head - Assemble".
Apply Tooling (B) to the bridge dowels and apply Tooling (B) to the bore of each valve bridge (3). Install the valve bridges in the original location and loosen the adjustment screws.
Use the procedure which follows to adjust the valve bridges.
Apply clean engine oil in the lubrication passage of the valve bridge (hole in top surface of cast web).
Back off the adjustment screw and press straight down on the top contact surface of valve bridge (3) with a force of 50 10 N (11 2 lb ft).
Turn the adjustment screw clockwise until the adjustment screw contacts the valve stem. A light touch is required to determine when contact is made.
Turn the screw for an additional 45 5 degrees in order to equalize clearance with the dowel. This is 1/8 of a turn.
Hold the adjustment screw in this position and tighten the locknut to a torque of 100 15 N m (75 11 lb ft).
Do this procedure for both valve bridges. Apply Tooling (B) to the top contact of both valve bridges and the unit injector.
Apply clean engine oil to each end of pushrods (1) and install the pushrods in the valve lifters. Install the pushrods in the original location.
Do not tighten the rocker arm shaft bolts until the rocker arm adjusting screws are loosened. Bent valves can result if the valves contact the pistons.
Place rocker arm assembly (2) on the rocker arm support.
Be sure that the sockets of the pushrods are engaged with the ball screws on the rocker arm.
Loosen the adjustment screws on the rocker arms.
While you are tightening the bolts that hold rocker arm assembly (2) to the rocker arm support to a torque of 430 60 N m (317 44 lb ft) with a torque wrench, use a pry bar in order to keep the rocker arm shaft centered on the rocker arm support.
Adjust the valve clearance. Refer to Testing and Adjusting, "Valve Lash and Valve Bridge Adjustment".
Adjust the fuel injector timing. Refer to Testing and Adjusting, "Fuel Timing". End By:
Install the valve cover.