828340 Volvo.Penta Fuel tank

Start By:
Remove the hydraulic oil cooler. Refer to Disassembly and Assembly, "Hydraulic Oil Cooler - Remove and Install". The information is in this module.
Effective July 1, 1992 regulations prohibit the venting of any refrigerant into the atmosphere. Refer to Caterpillar publications Service Manuals, SENR3334, SENR5664, and NEDG5065 for the proper procedure, the proper equipment, and the proper tools needed in order to reclaim refrigerant from any Caterpillar equipment.
Personal injury can result from contact with refrigerant.Contact with refrigerant can cause frost bite. Keep face and hands away to help prevent injury.Protective goggles must always be worn when refrigerant lines are opened, even if the gauges indicate the system is empty of refrigerant.Always use precaution when a fitting is removed. Slowly loosen the fitting. If the system is still under pressure, release it slowly in a well ventilated area.Personal injury or death can result from inhaling refrigerant through a lit cigarette.Inhaling air conditioner refrigerant gas through a lit cigarette or other smoking method or inhaling fumes released from a flame contacting air conditioner refrigerant gas, can cause bodily harm or death.Do not smoke when servicing air conditioners or wherever refrigerant gas may be present.Use a certified recovery and recycling cart to properly remove the refrigerant from the air conditioning system.
Note: Put identification marks on all lines, hoses, wires, and tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to prevent contaminants from entering the oil system.
Remove the refrigerant from the air conditioning system with a certified a/c recovery and recycling cart.
Illustration 1 g00289006
Disconnect two hose assemblies (3) from condenser (2) .
Remove four bolts (1) , and the nuts that secure condenser (2) to the transmission oil cooler.Note: Be careful to not damage the condenser during the removal procedure.
Remove condenser (2) from the transmission oil cooler.Installation Procedure
Illustration 2 g00289006
Position condenser (2) to the transmission oil cooler.
Install four bolts (1) , and the nuts that secure condenser (2) to the transmission oil cooler.
Check the O-ring seals that are in the hose assemblies that were disconnected. If the O-ring seals are worn or damaged, use new parts for replacement.
Connect two hose assemblies (3) to condenser (2) .
Personal injury or death can result when charging an air conditioning system with a liquid.The compressor will pump the refrigerant back into the charging cylinder with the possibility of rupturing (exploding) the cylinder.Do not operate the engine when charging with a liquid. Never charge liquid or gas through the discharge (high side of the system) with the engine running.Keep all other personnel either away from the machine or where they can be seen when working on the air conditioning system.
Evacuate the air conditioning system and charge the air conditioning system. Refer toService Manual, SENR5664, "Air Conditioning And Heating Systems With R-134A Refrigerant" .End By: Install the hydraulic oil cooler. Refer to Disassembly and Assembly, "Hydraulic Oil Cooler - Remove and Install". The information is in this module.