3854814 Volvo.Penta Gear set

Illustration 1 g03678296
Schematic diagram of the ARD air pump relay circuit
Illustration 2 g03346217
View of the pin location on the P1 connector for the ARD air pump relay
(54) ARD air pump relay
Table 1
Troubleshooting Test Steps Values Results
1. Inspect Electrical Connectors and Wiring
A. Turn the keyswitch to the OFF position.
B. Check the fuses.
C. Check the harness for abrasion and pinch points from the relay back to the ECM and from the relay back to the battery.
D. Check the harness for abrasions and pinch points from the ARD air pump back to the relay.
E. Thoroughly inspect the relay and the connector for the relay.
F. Perform a 45 N (10 lb) pull test on each of the wires in the ECM connector that are associated with the ARD air pump relay.
Loose connection or damaged wire
Result: There is a fault in a connector or the wiring.
Repair the connectors or the harness and/or replace the connectors or the harness. Ensure that all of the seals are correctly in place and ensure that the connectors are correctly connected. Replace any blown fuses.
Result: All connectors, pins, and sockets are correctly coupled and/or inserted. The harness and connectors are free of corrosion, abrasion, and pinch points. The fuses are OK.
Proceed to Test Step 2.
2. Override the ARD Air Pump Relay
A. Turn the keyswitch to the OFF position.
B. Connect