802740 Volvo.Penta Idler gear

Table 1
Diagnostic Trouble Codes    
CDL Code    J1939 Code    Code Description
(code descriptions may vary)    Comments    
246-14         Proprietary CAN Data Link: Special Instruction     The code is logged.    
247-14         SAE J1939 Data Link: Special Instruction     The code is logged.    
248-14         CAT Data Link: Special Instruction     The code is logged.    
296-14         Transmission Control : Special Instruction     The code is logged.    
562-14         Caterpillar Monitoring System : Special Instruction     The code is logged.    
596-14         Implement Control : Special Instruction     The code is logged.    
1273-14         Chassis Control Module : Special Instruction     The code is logged.    
1603-14         Machine Control Module : Special Instruction     The code is logged.    
3397-14     5495-14     DPF #1 Soot Loading Sensor : Special Instruction     The code is logged.    
3468-14     5576-14     Aftertreatment #1 Identification Number Module : Special Instruction     The code is logged.    
3472-14     5591-14     ARD Air Pressure Control System : Special Instruction     The code is logged.    
Table 2
Troubleshooting Test Steps    Values    Results    
1. Check for an Associated -9 Code
A. Establish communication between the Cat® Electronic Technician (ET) and the Electronic Control Module (ECM) for the engine.
B. Download a "Warranty Report" from the engine ECM before performing any troubleshooting or clearing diagnostic trouble codes.
   
Associated Trouble Code    
Result: An associated -9 code is logged.
Repair: Repair all associated -9 codes before continuing with this procedure. Refer to Troubleshooting, "Data Link - Test".
If a -14 code is still present after resolving the -9 code, proceed to Test Step 2.
Result: An associated -9 code is not logged.
Proceed to Test Step 2.
   
2. Check the Personality Module Code for Compatibility with the Application
A. Connect to Cat ET.
B. Select the ECM connection that is related to the logged code.
C. Check if the personality module code is valid for the application.
   
Compatible Personality Module    
Result: The code is valid for the application.
Proceed to Test Step 3.
Result: The code is not valid for the application.
Repair: Obtain the correct flash file and update the ECM. Reset all active codes and clear all logged codes. Return the unit to service.
   
3. Check the Configuration Parameters
A. Check the configuration parameters in order to ensure that the parameters are programmed correctly. Refer to Troubleshooting, "Configuration Parameters".
B. Select the ECM connection that is related to the logged code.
C. Check if the personality module code is valid for the application.
   
Correct Configuration Parameters    
Result: The configuration parameters are programmed correctly.
Proceed to Test Step 4.
Result: The configuration parameters are not programmed correctly.
Program the parameters to function with the other modules on the data link. Reset all active codes and clear all logged codes. Return the unit to service.
   
4. Check for Compatibility with Any Other ECM on the Data Link
A. Use the as shipped information found in SIS web TMI to determine if any other ECM or display on the data link are compatible.
B. Select the ECM connection that is related to the logged code.
C. Check if the personality module code is valid for the application.
   
Compatible ECM    
Result: The ECMs are not compatible.
Repair: Replace the incompatible ECM with the correct module. Reset all active codes and clear all logged codes. Return the unit to service.
   Test Step 1. Results:
The procedure corrected the issue. - STOP
The procedure did not correct the issue. - Repair: Contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN). STOP