3803734 Volvo.Penta Injection pump

Park the machine on a hard, level surface. Lower the scraper bowl to the ground and engage the parking brake. Chock the wheels in order to prevent the machine from moving. Turn the battery disconnect switch to the OFF position. Open the side access door to the engine.
Illustration 1 g00524332
Illustration 2 g00524333
Loosen two nuts (1) on rod (2) so that block (3) releases the tension on V-belt (4) .
Loosen bolt (5) . Loosen bolt (6) . Remove bolt (7) , the washers, and the nuts from block (3) . Remove bolt (5) and the washer that secures guard assembly (8) to alternator (9) . Remove guard assembly (8) from alternator (9) . Rotate alternator (9) toward the engine. Remove V-belt (4) from the pulley on the alternator. Reinstall bolt (5) .
Remove bolt (10) and the washer that secures rod (2) to the bracket. Remove the rod, the nuts, and the block from the bracket.
Illustration 3 g00524334
Pull back boot (11) . Remove bolt (12) from alternator (9) . Disconnect wire (13) from the terminal on the alternator.
Illustration 4 g00524335
Remove bolt (14) from alternator (9) . Disconnect wire (15) from the alternator. Disconnect wire (16) from alternator (9) .
Illustration 5 g00524336
Remove bolts (5) and (6) and the washers that secure alternator (9) to bracket (17) . Remove alternator (9) from the machine.
Illustration 6 g00524338
Remove bolt (18) that secures the washer, harness clip (19) , and bracket (17) to the gear cover. Remove two bolts (20) that secure bracket (17) to the gear cover. Remove bracket (17) from the gear cover.Installation Procedure
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Illustration 7 g00524338
Position bracket (17) to the gear cover. Install two bolts (20) that secure bracket (17) to the gear cover. Install bolt (18) that secures the washer, harness clip (19) , and bracket (17) to the gear cover.
Illustration 8 g00524336
Position alternator (9) to bracket (17) . Install bolts (5) and (6) and the washers that secure alternator (9) to bracket (17) . Do not tighten the bolts at this time.
Illustration 9 g00524335
Connect wire (16) to alternator (9) . Position wire (15) to the alternator. Install bolt (14) that secures wire (15) to alternator (9) .
Illustration 10 g00524334
Position wire (13) to the terminal on the alternator. Install bolt (12) that secures wire (13) to alternator (9) . Push boot (11) over the terminal.
Illustration 11 g00524333
Illustration 12 g00524332
Position rod (2) , the nuts, and the block to the bracket. Install bolt (10) that secures the rod to the bracket.
Rotate alternator (9) toward the engine. Install V-belt (4) to the pulley on the alternator. Remove bolt (5) . Position guard assembly (8) to alternator (9) . Install bolt (5) and the washer that secures guard assembly (8) to alternator (9) . Do not tighten bolt (5) at this time. Install bolt (7) , the washers, and the nuts to block (3) .
Tighten two nuts (1) on rod (2) so that block (3) creates the correct tension on V-belt (4) . Refer to Operation and Maintenance, SEBU7143 for the correct V-belt tension. Tighte