20459326 Volvo.Penta Inlet valve

Caterpillar Channel 1 Videos
For supplemental information on this procedure, refer to the following video. The previous training has been replaced with the video below.Note: A CWS login is required to access Caterpillar Channel 1. Scan the QR code below with a QR enabled device or copy the link that follows.
Illustration 1 g06306276https://channel1.mediaspace.kaltura.com/media/Introduction+to+Visualization+Service+Procedures+%28VSP%29/1_92vjr92v
Important Safety Information
Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards, including human factors that can affect safety. This person should also have the necessary training, skills, and tools to perform these functions properly.Improper operation, lubrication, maintenance, or repair of this product can be dangerous and could result in injury or death.Do not operate or perform lubrication, maintenance, or repair on this product, until you verify that you are authorized to perform this work, and have read and understood the operation, lubrication, maintenance, and repair information.The information, specifications, and illustrations in this publication are based on information that was available at the time that the publication was written. The specifications, torques, pressures, measurements, adjustments, illustrations, and other items can change at any time. These changes can affect the service that is given to the product. Obtain the complete and most current information before you start any job. Cat dealers have the most current information available.In the United States, the maintenance, replacement, or repair of the emission control devices and systems may be performed by any repair establishment or individual of the owner choosing.Welding on Electronically Controlled Engines
Proper welding procedures are necessary in order to avoid damage to electronic controls. Perform welding on the engine, SCR, or locomotive frame according to the following procedure.
Turn the engine OFF.
If the unit is equipped with a locking EFCO button, depress and lock the EFCO button.
Open the main DC Knife Switch.
If the unit is equipped with a battery disconnect switch, open the switch (located by the main battery compartment).
Remove all electrical harness or wiring connections to any microprocessor. This includes but is not limited to, the engine ECM, LCM, TCM, PE Box, DVR/Interface Box, and any other electrically sensitive equipment.
Disconnect the negative battery cable from the battery (24V and 64V as equipped).
DO NOT use electrical components in order to ground the welder.
Do not use the ECM or sensors or any other electronic component in order to ground the welder.General Information
Graphic Color Description
Color-coding of targeted components, or sections of a part, is used to communicate a required action.The descriptions below illustrate the different colors and what is represented when used in a graphic.
(Blue) The primary component of focus for a particular step. Target or primary component to be installed or removed. Installation implied unless otherwise noted with a symbol.
(CAT® Yellow) Description of parts.
(Cyan) Special tools or other equipment required for use in a particular step.
(Light Gray) Components used for reference.
(Magenta) Any fastener, retainer, or electrical connector used to install or remove the primary component.Graphic Symbol Description
This section includes all the symbol graphics used throughout the Visual Service Procedure (VSP), along with a brief description of what the symbol represents.
Attach
Compress, Load - To press together, to squeeze. To transfer weight or force to an object. The weight or force carried by an object.
Insert - To place or fit into another object