467861 Volvo.Penta Inlet valve

Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-3527     Valve Spring Compressor     1    
B     4C-8134     Seal Remover     1    
1U-7600 Slide Hammer Puller Gp     1    Start By:
Remove the cylinder head assembly. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean the bottom face of the cylinder head. Check the depth of the valves below the face of the cylinder head before the valve springs are removed. Refer to Specifications, "Cylinder Head Valves" for the correct dimensions.
Place a temporary identification mark on the heads of the valves in order to identify the correct position.Note: Do not stamp the heads of the valves. Stamping or punching the heads of the valves could cause the valves to fracture.
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Ensure that the valve spring is compressed squarely or damage to the valve stem may occur.
Illustration 1 g01333469
Typical example
Illustration 2 g01333471
Typical example
Use Tooling (A) in order to compress the appropriate valve spring (3). Remove valve keepers (1) .Note: Do not compress the valve spring so that valve spring retainer (2) touches valve stem seal (4) .
Remove Tooling (A) .
Remove valve spring retainer (2). Remove valve spring (3) .
Remove valve (5) .
Use Tooling (B) to remove valve stem seal (4) .
Repeat Steps 3 through 7 in order to remove the remaining inlet and exhaust valves.Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-3527     Valve Spring Compressor     1    
C     4C-6373     Seal Installer     1    
4C-6366 Valve Guide Driver     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean all components of the cylinder head assembly. Ensure that all ports, all coolant passages and all lubrication passages in the cylinder head are free from debris. Follow Steps 1.a through 1.e in order to inspect the components of the cylinder head assembly. Replace any components that are worn or damaged.
Inspect the cylinder head for wear and for damage. Refer to Systems Operation, Testing and Adjusting, "Cylinder Head Inspect".
Inspect the valve seats for wear and for damage. Refer to Specifications, "Cylinder Head Valves" for further information.
Inspect the valve guides for wear and for damage. Refer to Specifications, "Cylinder Head Valves" and Systems Operation, Testing and Adjusting, "Valve Guide - Inspect" for further information.
Inspect the valves for wear and for damage. Refer to Specifications, "Cylinder Head Valves".
Inspect the valve springs for the correct length. Refer to Specifications, "Cylinder Head Valves".
Illustration 3 g01333472
Typical example
Use Tooling (C) to install new valve stem seals (4) onto each of the valve guides.
Illustration 4 g01333471
Typical example
Lubricate the stem of valve (5) with clean engine oil. Install valve (5) in the appropriate position in the cylinder head. Check the depth of the valve below the face of the cylinder head. Refer to Systems Operation, Testing and Adjusting, "Valve Depth - Inspect" for more information.
Install valve spring (3) to the cylinder head. Positio