20459171 Volvo.Penta Nipple

"Equipment ID"
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field."Engine Serial Number"
The "Engine Serial Number" should be programmed in order to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM."(FLS)" Full Load Setting
"Full Load Setting" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information ratings plate. This value should only be changed if the engine is rerated or a new ECM is installed. Factory passwords are required."(FTS)" Full Torque Setting
"Full Torque Setting" is similar to "Full Load Setting". This value should only be changed if the engine is rerated or a new ECM is installed. Factory passwords are required."Variable Pitch Engine Fan"
The "Variable Pitch Engine Fan" parameter allows the variable pitch engine fan feature to be enabled or disabled."Variable Pitch Engine Fan Blade Cooling Position"
The "Variable Pitch Engine Fan Blade Cooling Position" parameter allows the customer to specify the cooling position of the engine fan blade."Engine Fan Purge Cycle Interval"
The "Engine Fan Purge Cycle Interval" parameter allows the customer to set the time interval between purges."Engine Fan Purge Cycle Duration"
The "Engine Fan Purge Cycle Duration" parameter allows the customer to set the duration of an individual purge."Engine Fan Suspend Purge"
The "Engine Fan Suspend Purge" parameter allows the suspend purge in forward gear feature to be enabled or disabled."Engine Fan Manual Purge"
The "Engine Fan Manual Purge" parameter allows the manual purge button to be enabled or disabled."Engine Fan Control"
The "Engine Fan Control" parameter is not supported."Top Engine Fan Speed"
The "Top Engine Fan Speed" parameter is not supported.Parameter Table
Table 1
System Configuration Parameters    
Parameter    Available Range or Options    Default    Required Password    
"Equipment ID"     17 characters     blank     none    
"Engine Serial Number"     8 characters     blank     Factory    
"FLS"     -128 to +127     0     Factory    
"FTS"     -128 to +127     0     Factory    
"Ether Control"     "Enabled" or "Disable"     "Enabled"     Factory    
Flexxaire Fan (Variable Pitch)    
"Variable Pitch Engine Fan"     "Enabled" or "Disabled"     "Disabled"     none    
"Variable Pitch Engine Fan Blade Cooling Position"     "Push" or "Pull"     "Push"     none    
"Engine Fan Purge Cycle Interval"     5 to 120 minutes     1200 seconds     none    
"Engine Fan Purge Cycle Duration"     5 to 30 seconds     15 seconds     none    
"Engine Fan Suspend Purge"     "Enabled" or "Disabled"     "Disabled"     none    
"Engine Fan Manual Purge"     "Enabled" or "Disabled"     "Enabled"     none    
"Eng Fan Temp Dependent Radiator Purge"     This feature is not supported.        
Rockford Fan    
"Engine Fan Control"     This feature is not supported.        
"Top Engine Fan Speed"     This feature is not supported.        
"Engine Security System Status"     "Unavailable"     "Unavailable"     Factory    Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters    
"Equipment ID"    
   
"Engine Serial Number"    
   
"Personality Module Part Number"    
   
"Personality Module Description"    
   
"Ether Control"    
   
"FLS"    
   
"FTS"    
   
"Flexxaire Fan (Variable Pitch)"