871037 Volvo.Penta Propeller

Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
Rating Number 1 or 2 1 None
Rated Power (1) Read Only
Rated Peak Torque (1) Read Only
Top Engine Speed Range (1) Read Only
Test Spec (1) Read Only
Equipment ID (2) 17 alphanumeric characters NOT PROGRAMMED None
Engine Serial Number (2) 0XX00000 or XXX00000 0XX00000 None
ECM Serial Number (1) Read Only
ECM Part Number (1) Read Only
Software Group Part Number (1) Software Dependent Read Only
Software Group Release Date (1) Software Dependent Read Only
Software Group Description (1) Software Dependent Read Only
FLS (Full Load Setting) (2) -128 to 127 0 Factory
FTS (Full Torque Setting) (2) -128 to 127 0 Factory
Ether Solenoid Configuration (2) No Ether
Continuous Flow Continuous Flow None
System Battery Voltage Low Elevated Idle (2) Disabled
Enabled Enabled None
Total Tattletale Read Only
(1) This parameter can only be viewed. No changes are allowed.
(2) The parameter must be reprogrammed if the ECM is replaced.Parameter Descriptions
Rating Number
This machine engine has two power ratings. The ECM is programmed to automatically change the power rating of the engine when certain conditions are present. The conditions are specified in two features that are available for the machine.The status of the power rating is dependent on the status of the transmission gear and the implement controls.The "Rating Number" parameter provides a way to view the information on each rating. Changing this parameter does not select the engine power rating.Equipment ID
"Equipment ID" allows the customer to enter a description into the Electronic Control Module (ECM) in order to identify the machine. A maximum of 17 characters may be entered in the field. This parameter is only for reference by the customer. This parameter is not required.Engine Serial Number
Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. If the ECM is replaced, the engine serial number from the engine information plate must be programmed into the new ECM.Note: When you are requesting factory passwords, always use the engine serial number that is programmed in the ECM.FLS (Full Load Setting)
"FLS" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Factory passwords are required in order to change this parameter.FTS (Full Torque Setting)
"FTS" is similar to "FLS". Factory passwords are required in order to change this parameter.Ether Solenoid Configuration
Program the "Ether Solenoid Configuration" to "Continuous Flow" if an ether injection system is installed on the engine.System Battery Voltage Low Elevated Idle
Set the "System Battery Voltage Low Elevated Idle" parameter to "Enabled" in order to help maintain a proper charge on the batteries when electrical accessories have been added by the customer. This feature increases engine rpm to 1000 when the following conditions are met:
The parameter is set to "Enabled".
System battery voltage is less than 24.5 VDC for five minutes.
The throttle pedal position is below 25 percent for five minutes.
The machine is not in gear.
The parking brake is set.The engine rpm will return to low idle when any of the following conditions occur:
The parking brake is released.
The transmission is not in neutral.
The throttle is above 25 percent.Parameters Worksheet
Table 2
Engine Parameters
Rating Number
Rated Power
Rated Peak Torque
Top Engine Speed Range
Test Spec
Equipment ID
Engine Serial Number
ECM Serial Number
ECM Part Number
Software Group Part Number&