941128 Volvo.Penta Screw


941128 Screw Volvo.Penta D42A; D42A PP Screw
941128 Screw Volvo Penta
Rating:
103

Buy Screw 941128 Volvo Penta genuine, new aftermarket parts with delivery
Number on catalog scheme: 18
 

Compatible models:

D42A; D42A PP   Volvo.Penta

Volvo Penta entire parts catalog list:

D42A; D42A PP

Information:

Recommended Actions
Diagnostic Codes, Event Codes, and Electrical Power Supply to the ECM
Certain diagnostic codes and/or event codes may prevent the engine from starting. Connect Caterpillar Electronic Technician (ET) and check for active codes and/or for logged codes. Troubleshoot any codes that are present before continuing with this procedure.Note: If Cat ET will not communicate with the ECM, the problem is most likely with the electrical power supply to the ECM. Refer to Troubleshooting, "Electrical Power Supply - Test".Fuel Supply
Visually check the fuel level. Do not rely on the fuel gauge only. If necessary, add fuel. If the engine has been run out of fuel, prime the fuel system. Refer to Operation and Maintenance Manual for the correct procedure.
Check the fuel lines for the following problems: restrictions, collapsed lines and pinched lines. If problems are found with the fuel lines, repair the lines and/or replace the lines.
Check the fuel tank for foreign objects which may block the fuel supply.
Prime the fuel supply system if any of the following procedures have been performed:
Replacement of the fuel filters
Service on the low-pressure fuel supply circuitNote: A sight glass in the supply line is helpful in diagnosing air in the fuel.
Cold weather adversely affects the characteristics of the fuel. Refer to the Operation and Maintenance Manual for information on improving the characteristics of the fuel during cold-weather operation. Electrical Power Supply to the Electronic Control Module (ECM)
Check power to the ECM. Refer to Troubleshooting, "Electrical Power Supply - Test".Note: If the ECM is not receiving battery voltage, the ECM will not communicate.Electrical Connectors
Inspect each connector for moisture and corrosion. Also, inspect the harness from the ECM to the sensors. Refer to Troubleshooting, "Electrical Connectors - Inspect".Air Inlet and Exhaust System
Check the air filter restriction indicator for a plugged filter. If necessary, service the engine. Refer to the Operation and Maintenance Manual.
Check the air inlet and exhaust system for restrictions and/or leaks. Engine Shutdown Switches (if applicable)
The engine shutdown switches should be in the OFF position. Use Cat ET to verify the status of the shutdown switches. When a shutdown occurs, the keyswitch must be turned to the OFF position for at least 15 seconds before restarting the engine.Engine Speed/Timing
Crank the engine and observe the engine speed on the Cat ET status screen. If Cat ET indicates zero rpm, refer to Troubleshooting, "Speed/Timing - Test". Note: Upon initial cranking, the status for engine speed may indicate that the engine speed signal is abnormal. This message will be replaced with an engine speed once the ECM is able to calculate a speed from the signal.
Ensure that the timing reference gear is installed correctly. The engine will not start if the gear was installed backward. Check for proper orientation between the crankshaft and camshaft drive gears. Correct the orientation and/or replace the drive gear, if necessary. Refer to the Disassembly and Assembly manual. Unit Injectors
Perform the "Injector Solenoid Test" on Cat ET in order to determine if all of the injector solenoids are being energized by the ECM. Refer to Troubleshooting, "Injector Solenoid - Test" for additional information.Combustion
Check for mechanical problems in the combustion system.


Parts screw Volvo Penta:

840626
 
840626 Screw kit
2001; 2001B; 2001AG, 230A; 230B; 250A, 430; 430A; 430B, 500; 500A; 501A, 571A, 740A; BB740A, AD30A; AQAD30A; MD30A, AQ120B; AQ125A; AQ140A, AQ125B, AQ131A; AQ131B; AQ131C, AQ145A; BB145A, AQ145B, AQ151A; AQ151B; AQ151C, AQ171A; AQ171C, AQ175A, AQ200B
6211936
 
6211936 Screw
2001; 2001B; 2001AG, AD30A; AQAD30A; MD30A, AD31D; AD31D-A; AD31XD, AD31L-A; AD31P-A; AD41L-A, AD41D; D41D; TAMD41D, D42A; D42A PP, MD31A; TMD31A; TMD31B, MD31A; TMD31B; TAMD31B, MD40A; TMD40A; TMD40B, TD30A; TD31ACE; TD40A, TD60D; TD60D-83; TD60DPP-
827568
 
827568 Screw kit
AQ115A; AQ115B; AQ130, D100A; D100AK; D100B, D42A; D42A PP, MD100A; TMD100A; TMD100AK, MD1B; MD2B; AQD2B, MD21B; AQD21B, TD30A; TD31ACE; TD40A
899675
 
899675 Screw
D100A; D100AK; D100B, D42A; D42A PP, D70B; D70B PP; D70B K
956556
 
956556 Screw
D42A; D42A PP, TD30A; TD31ACE; TD40A
926312
Screw
926312 Screw
D42A; D42A PP
6645050
 
6645050 Screw
D42A; D42A PP
6211933
 
6211933 Screw
D42A; D42A PP, TD30A; TD31ACE; TD40A
Back to top