242953 Volvo.Penta Spring

Table 1
Required Tools
Tool Part Number Part Description Qty
A 439-3938 Link Bracket 2 Start By:
Remove the engine enclosure.
Remove the enclosure (cooling system package).
Personal injury can result from contact with refrigerant.Contact with refrigerant can cause frost bite. Keep face and hands away to help prevent injury.Protective goggles must always be worn when refrigerant lines are opened, even if the gauges indicate the system is empty of refrigerant.Always use precaution when a fitting is removed. Slowly loosen the fitting. If the system is still under pressure, release it slowly in a well ventilated area.Personal injury or death can result from inhaling refrigerant through a lit cigarette.Inhaling air conditioner refrigerant gas through a lit cigarette or other smoking method or inhaling fumes released from a flame contacting air conditioner refrigerant gas, can cause bodily harm or death.Do not smoke when servicing air conditioners or wherever refrigerant gas may be present.Use a certified recovery and recycling cart to properly remove the refrigerant from the air conditioning system.
Recover the air conditioner refrigerant from the air conditioner system. Refer to Service Manual, SENR5664, "All Products Air Conditioning and Heating R134a for All Caterpillar Machines" for the correct procedure. Refer to Special Publication, PERJ1017, "Air Conditioning Tools" for the correct tools.
Personal injury can result from hot coolant, steam, and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and allow sufficient time for the cooling system to cool.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Drain the coolant from the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Drain the hydraulic from hydraulic system. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the correct draining and filling procedures.
Illustration 1 g06376941
Disconnect hose assembly (1).
Illustration 2 g06376958
Disconnect harness assemblies (2) and (4). Remove bolt (3).
Illustration 3 g06376962
Loosen clamp (6) and disconnect tube assembly (5).
Illustration 4 g06376967
Disconnect hose assembly (7) and remove clip (8).
Illustration 5 g06376971
Loosen clamp (9) and disconnect tube (10).
Illustration 6 g06376998
Install Tooling (A) and attach a suitable lifting device to radiator guard and support assembly (11). The weight of radiator guard and support assembly (11) is approximately 458 kg (1010 lb).
Illustration 7 g06376983
Remove two bolts (12). Repeat for the other side.
Illustration 8 g06377289