95870A 4 Mercruiser EXHAUST ELBOW ASSEMBLY, LOWER


95870A 4 EXHAUST ELBOW ASSEMBLY, LOWER Mercruiser 01207333, 01402414, 01407333, 04707333, 04708004, 04881333 EXHAUST
95870A 4 EXHAUST ELBOW ASSEMBLY, LOWER Mercruiser
Rating:
23

Buy EXHAUST ELBOW ASSEMBLY, LOWER 95870A 4 Mercruiser genuine, new aftermarket parts with delivery
Number on catalog scheme: 10
 

Compatible models:

Mercruiser entire parts catalog list:

01207333 1983
01402414 1984,1985,1986,1987,1988,1989
01407333 1983
04707333 1983
04708004 1984
04881333 1983

Information:


Table 1
Diagnostic Trouble Code for Intake Manifold Air Pressure Is High
J1939 Code Code Description Comments
102-16 Engine Intake Manifold #1 Pressure : High - moderate severity (2) This pressure is a variable value that is calculated by the ECM. The resulting value depends on the operating conditions of the engine. Probable Causes
Turbocharger electronic wastegate regulatorRecommended Actions
Table 2
Troubleshooting Test Steps Values Results
1. Download Information Using the Electronic Service Tool
A. Use the electronic service tool to download the "Product Status Report" (PSR) with histograms before performing any troubleshooting or clearing any diagnostic codes.
Note: The downloaded information will be required by the Dealer Solutions Network (DSN) if troubleshooting assistance is required.
Downloaded information
Result: The information was successfully saved.
Proceed to Test Step 2.
Result: The electronic service tool information was not successfully saved.
Contact the Dealer Solutions Network (DSN) for guidance.
2. Create an Electronic Service Tool Snapshot
A. Select "Snapshot Viewer" on the electronic service tool, using menus: Information -> Snapshot -> Viewer
B. Select the event code and then click "View Graph".
C. Select the following parameter and then click OK.
Engine Speed
D. Select Save to "File to save" a Snapshot File (*.xml). This file will contain all the data in the snapshot and not only the data shown on the graph.
Note: The downloaded information will be required by the DSN if troubleshooting assistance is required.
Snapshot saved
Result: The electronic service tool snapshot was successfully saved.
Proceed to Test Step 3.
Result: The electronic service tool snapshot was not successfully saved.
Contact the DSN for guidance.
3. Turbocharger Electronic Wastegate Regulator
A. Use the electronic service tool to perform the "Air System Motor Valves Verification Test" to check that the turbocharger wastegate is operating correctly.
B. Inspect the turbocharger. Refer to Systems Operation, Testing and Adjusting, "Turbocharger - Inspect".
Turbocharger wastegate
Result: Diagnostic codes became active during the "Air System Motor Valves Verification Test"
Repair: Troubleshoot the diagnostic codes. Refer to Troubleshooting, Diagnostic Trouble Codes.
If the wastegate is not operating correctly, disconnect the linkage from the actuator by removing the circlips. Check the crank on the turbine housing for free movement. If the crank moves freely, replace the wastegate actuator.
If the turbocharger wastegate is replaced, use the electronic service tool to perform the "Turbocharger Wastegate Actuator Replacement Reset".
Use the electronic service tool to perform the "Air System Motor Valve Verification Test" to verify that the repair eliminates the fault.
If the crank does not move freely, replace the turbocharger assembly. Refer to Disassembly and Assembly , Turbocharger - Remove and Disassembly and Assembly , Turbocharger - Install.
If the turbocharger is replaced, use the electronic service tool to perform the "Turbocharger Wastegate Actuator Replacement Reset".
Use the electronic service tool to perform the "Air System Motor Valve Verification Test" to verify that the repair eliminates the fault.
Result: There is a suspected fault in the wastegate or the wastegate actuator.
Repair: Replace the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove" and Disassembly and Assembly, "Turbocharger - Install".
If the turbocharger is replaced, use the electronic service tool to perform the "Turbocharger Wastegate Actuator Replacement Reset".
Use the electronic service tool to perform the "Air System Motor Valve Verification Test"
Result: The wastegate and the wastegate actuator operate correctly.
If the fault is still present, contact the DSN and provide the following information from Test Step 1 and Test Step 2:
• PSR and Histograms
• Snapshot data


Parts exhaust Mercruiser:

94018A 1
 
94018A 1 EXHAUST ELBOW ASSEMBLY
00014332, 01207333, 01402414, 01407333, 02287333, 02602347, 02607333, 02608427, 08986342, 08987343, 228801, 257B021JS, 260801, 40500006T, 40500010T, 40500010U, 40500120U, 444106LPS, 444236HRS, 457B100KS, 4M11025RS, 4M11025TS, 4M11025TT, 4M11025US, 4M
94608A 1
 
94608A 1 EXHAUST TUBE ASSEMBLY
00014332, 01207333, 01402414, 01407333, 02287333, 02602347, 02607333, 02608427, 08986342, 08987343, 228801, 257B021JS, 260801, 457B100KS
70981A 3
EXHAUST BELLOWS
70981A 3 EXHAUST BELLOWS
00014332, 01207333, 01402414, 01407333, 01701335, 01851333, 01854335, 02287333, 02602347, 02607333, 02608427, 03307332, 03308333, 04544347, 04707333, 04708004, 04881333, 08986342, 08987343, 228801, 260801, 4V71222ND, 4V71222PD, 4V71222TD
53272A 1
 
53272A 1 EXHAUST ELBOW ASSEMBLY
01206002, 01207333, 01326013
45597
 
45597 EXHAUST BELLOWS, UPPER
01206002, 01207333, 01326013
98626A 3
 
98626A 3 EXHAUST SEPARATOR
00014332, 01207333, 01402414, 01407333, 02287333, 02602347, 02607333, 02608427, 08987343, 257B021JS, 40500006T, 40500010T, 40500010U, 40500120U, 444106LPS, 444236HRS, 457B100KS, 4M11025RS, 4M11025TS, 4M11025TT, 4M11025US, 4M4102LPS, 4M4102LRS, 4M4102
41191A 1
 
41191A 1 EXHAUST ELBOW ASSEMBLY
01207333, 01402414, 01407333
96107A 1
 
96107A 1 EXHAUST PIPE ASSEMBLY, UPPER
01207333, 01402414, 01407333
Back to top